Minka Lavery 5328-577 Installation guide

Brand: Minka Lavery

Model: 5328-577

Type: Installation guide

Minka Lavery 5328-577 is a versatile and stylish lighting fixture that can elevate the ambiance of any room. With its intricate decorative arms and elegant glass shade, it provides both ambient and task lighting, making it suitable for various settings.

The fixture comes with easy-to-follow instructions, allowing for a hassle-free installation. It features adjustable arms, enabling you to customize the spread of light to suit your specific needs. The secure mounting system ensures stability, while the included finials add a touch of sophistication.

INSTALLATION INSTRUCTION FOR 5328-577

WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER .

AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.

READ AND SAVE THESE INSTRUCTIONS

PREPARATION

1. Shut off the power at the circuit breaker box. If

necessary, remove the old fixture and all

mounting hardware from junction box.

2. Carefully unpack your new fixture and lay out all

the parts on a clear area. Take care not to loose

any small parts necessary for installation.

ASSEMBLING THE FIXTURE (Fig. 1)

3. Spread the arms (J) so that the arms (J) are at

equal distance from each other.

4. Secure the part (I) of the decorative arms (F) to

the canopy (D) with the screws (G), then secure

the part (II) of the decorative arms (F) to the

coupling (I) with the screws (G).

5. Thread the nut (L) onto the nipple (M), then thread

the nipple (M) into the coupling (K) and tighten

with the nut (L).

6. Install the light bulb(s) in accordance with the

fixture’s specifications (DO NOT EXCEED THE

MAXIMUM WATTAGE!) (NE PAS DEPASSER

LA PUISSANCE NOMINALE MAXIMALE!)

7. Slide the glass (N), plastic washer (O) and iron

washer (P) over the nipple (M) and secure with

the nut (Q).

8. Slide the cap (R) over the nipple (M), and secure

with the finial (S).

MOUNTING THE FIXTURE (Fig.1)

9. Thread the two mounting screws (A) (Size: #8-

32*1.1”L) part way into the crossbar (B). Secure

the crossbar (B) to junction box (not provided)

with the junction box screws (C) (Size: #8-

32*0.6”L) through the slotted holes in mounting

bar (B). The side of the mounting bar (B) marked

“GND” must face out.

CONNECTING THE WIRES (Fig. 2)

10. Connect the fixture wires to the junction box wires

as shown in Fig. 2, making sure all wire

connectors are secured. If your outlet box has a

ground wire (green or bare copper) connect the

fixture’s ground wire to it. Otherwise, connect the

fixture’s ground wire directly to the mounting plate

using the green screw provided. After the wires

are connected, tuck them neatly inside the

junction box.

COMPLETING THE INSTALLATION (Fig. 1)

12. Raise the canopy (D) allowing for the mounting

screws (A) to protrude through the holes on the

canopy (D), then secure with the finials (E).

Return the power to the junction box and test the

fixture. Your installation is now complete.

Fig.1

Fig . 2

Set

-Crossbar

-Ground screw

-Mounting screw*2

A-

016

Minka Lavery 5328-577 Installation guide

Brand: Minka Lavery

Model: 5328-577

Type: Installation guide

Download PDF

report

Minka Lavery 5328-577 Installation guide

Minka Lavery 5328-577 Installation guide

Related papers

Other documents