Introduction
The Micronet Gaia Speed Dome series (SP5553HDC/
SP5554HDC) provides high resolution image quality at low
bandwidth with H.264, the new generation compression
technology, for professional outdoor IP surveillance application.
M-JPEG, MPEG-4, H.264 dual streams simultaneously allows
more flexibility in practice by assigning different streaming,
frame size, bit rate, and frame rate to satisfy various
requirements.
Package Contents
Before you start installing the device, verify the following items
are in the package:
One Gaia series Speed Dome
One Quick Installation Guide
One Installation CD
One Power Adapter
One Wall Mount Bracket
One Wall Mount Kit
System Requirement
Networking
LAN: 10Base-T Ethernet or 100Base-TX Fast Ethernet.
Accessing the Camera using Web Browser
Platform: Microsoft® Windows® 2000/XP/Vista
CPU: Pentium 4, 2.4GHz or Above
RAM: 512MB
Resolution: SVGA or XGA with 1024 x 768 Resolution
System: DirectX 9.0C or Above
User Interface: Microsoft® Internet Explorer 6.0 or above
Hardware Installation
1
3
4
2
c. Insert the all camera connectors into
outdoor housing.c.
Step 1: Installing the Speed Dome
a. Release the screw and
open the electrical board.
Step 1:
Step 1: a.
Step 1:
Step 1: a.
Step 1: a.
Step 1: a.
b. Feed the all camera
connectors through the
hole of the wall mount
racket.
a.
Srew
d. The cables should go through the
center of the electrical board, connect
the connectors in order as
below.(Yellow/Green connector to J13,
Black/Red connector to J12)
c.
c.
c.
c.
e. Use the screw to secure the electrical board.
b.
c.
d.
Yellow/Green(Connect to J13)
Terminal(connector)
Black/Red(Connedt to J12)
1 2 3
1
2
3
e.
Srew
f. Put the “Main Machine part” to
right position. Note that the tiny
protrusion on upper dome body
must match to the holes on lower
electrical board.
(Position A to A, B to B, C to C)
c.
c.
c.
c.
c.
C
A
B
C
A B
g. Fasten the front cover to
the outdoor housing.
Clockwise until it catches
the tabs and stops.
c.
c.
c.
g.
f.