1
Specifications:
the fan running. This device will automatically reset as the temperature reduces.
Switch the rocker switch to 0.•
If the heater is not in regular daily use disconnect from the power supply.
The FF3 is fitted with a digital remote thermostat as standard.
Setup and operation:
The FF3HT is fitted with a high quality axial fan motor.
with the appropriate uk mains plug.
The appliance is connected to a 13Amp 50Hz power supply and comes fitted
The FF3HT is a 3Kw single phase industrial high temperature electric fan heater.
Protective /safety devices:
•
To start:
Please note ! the control panel is at the rear of the appliance.•
Site the appliance on a firm level surface.•
connect to the appropriate power supply.•
Switch the rocker switch to I. •
Set the thermostat to the desired temperature.•
Setting the digital thermostat:(see diagram P4)
The digital thermostats 'set point' (the temperature that the unit operates
up to and ceases to operate at) has been factory set at 60 C. At 62 C the
unit will stop heating(the fan will continue to operate). The unit will recommence
heating when the temperature drops below 60 C.
To change the thermostat 'set point':
Press and hold the 'set' button until the 'set point' (60 C) appears•
flashing on the screen.
Release the 'set' button and use the 'up' & 'down' arrows to change •
the 'set point'
Leave the thermostat to return to it's normal display of ambient •
temperature.
To stop the machine:
The FF3HT is fitted with a safety limit thermostat. Should the maximum design •
operating temperature be exceeded it will shut down the heating element and leave
3