2. Vango
  3. Lomond 400 canopy

Vango Lomond 400 canopy, Lomond 600 canopy Pitching Instructions

  • Hello! I've reviewed the pitching instructions for the Lomond 400 and 600 front canopies. This document outlines how to assemble the canopy, including the pole setup, tensioning, and securing it to your tent. I'm ready to answer any questions you have about these instructions.
  • Where should the open end of the canopy be positioned?
    How do you secure the canopy to the tent?
    Where should the canopy be used?
IF YOU HAVE ANY PROBLEMS PLEASE CONTACT YOUR LOCAL RETAILER or
AMG Group Ltd., Kelburn Business Park, Port Glasgow, Scotland. PA14 6TD.
UK Consumer Hotline: 0844 811 0535 E-Mail: [email protected].uk
Calls to our Customer Hotline cost 5p per minute. Calls from mobile phones, cable networks or public payphones will generally cost more.
Pitching Instructions – Lomond 400 & 600 Front Canopy
Pitching Instructions
Assemble the poles and insert into pole sleeves.
Locate one end of the poles in Ring & Pin system as Figure 1 below.
Push poles into an arch from opposite side and locate other pole end on to
corresponding Ring & Pin system on flysheet.
Tension the webbing strap at the pole end.
Position the open end of canopy towards tent.
Secure in position by clipping the canopy roof webbing straps onto the second tent
pole sleeve.
Peg out canopy base at contact point with tent and attach canopy rear side clips
onto second tent pole.
Peg out front of canopy.
Secure in position by pegging out front guy lines.
Peg out ALL remaining peg points as figure 2.
The Vango Lomond Canopy is designed for use in lowland sheltered campsites.
Do not pitch in high winds or exposed campsites.
Figure 1.
Figure 2.
/