2. Vango
  3. Loire 400 front canopy

Vango Loire 400 front canopy Pitching Instructions

  • Hello! I've reviewed the instructions for the Vango Loire 400 Front Canopy. This document describes how to attach the canopy to the front of the tent using a pole and peg system. It also emphasizes that the canopy is designed for lowland sheltered campsites. I'm ready to answer your questions about it.
  • Where is the Loire Front Canopy designed for use?
    Should I pitch the canopy in high winds?
    How do I secure the canopy?
IF YOU HAVE ANY PROBLEMS PLEASE CONTACT YOUR LOCAL RETAILER or
AMG Group Ltd., Kelburn Business Park, Port Glasgow, Scotland. PA14 6TD.
UK Consumer Hotline: 0844 811 0535 E-Mail: [email protected].uk
Calls to our Customer Hotline cost 5p per minute. Calls from mobile phones, cable networks or public payphones will generally cost more.
Pitching Instructions
Assemble the poles and insert into pole sleeves.
Locate one end of the poles in Ring & Pin system as Figure 1 below.
Push poles into an arch from opposite side and locate other pole end on to
corresponding Ring & Pin system on flysheet.
Tension the webbing strap at the pole end.
Position open end of canopy towards tent front door.
Secure in position by clipping the canopy roof webbing straps onto the second tent
pole sleeve.
Peg out canopy base at contact point with tent and attach rear side canopy clips to
front tent pole.
Peg out front of canopy and front guylines.
Peg out ALL remaining guylines and peg points as figure 2.
The Vango Loire Front Canopy is designed for use in lowland sheltered campsites.
Do not pitch in high winds or exposed campsites.
Figure 1.
Figure 2.
Pitching Instructions – Loire 400 Front Canopy
/