2. Vango
  3. Palena DLX 500 Canopy

Vango Palena DLX 500 Canopy, Palena DLX 600 Canopy Pitching Instructions

  • Hello! I've reviewed the pitching instructions for the Vango Palena DLX 500 and 600 Front Canopies. This document outlines the steps for assembling and securing the canopy, including the pole system, zipping and clipping attachments, and pegging out the base and guylines. I'm ready to answer any questions you may have about setting up your canopy.
  • What is the Vango Palena DLX Front Canopy designed for?
    Should I pitch the canopy in high winds?
    How do I secure the canopy?
IF YOU HAVE ANY PROBLEMS PLEASE CONTACT YOUR LOCAL RETAILER or
AMG Group Ltd., Kelburn Business Park, Port Glasgow, Scotland. PA14 6TD.
UK Consumer Hotline: 0844 811 0535 E-Mail: [email protected].uk
Calls to our Customer Hotline cost 5p per minute. Calls from mobile phones, cable networks or public payphones will generally cost more.
Pitching Instructions
Assemble the poles and insert into pole sleeves.
Locate one end of the poles in Ring & Pin system as Figure 1 below.
Push poles into an arch from opposite side and locate other pole end on to
corresponding Ring & Pin system on flysheet.
Tension the webbing strap at the pole end.
Position open end of canopy towards tent front door.
Secure in position by zipping canopy onto corresponding zip at front of tent and
clipping the rear canopy clips onto the front tent pole.
Peg out canopy base at contact point with tent and attach rear side canopy clips to
front tent pole.
Peg out front of canopy and front guylines.
Peg out ALL remaining guylines and peg points as figure 2.
The Vango Palena DLX Front Canopy is designed for use in lowland sheltered campsites.
Do not pitch in high winds or exposed campsites.
Figure 1.
Figure 2.
Pitching Instructions – Palena DLX 500 & 600 Front Canopy
/