2. Vango
  3. Excel side canopy

Vango Excel side canopy Pitching Instructions

  • Hello! I'm your chat assistant, and I've reviewed the pitching instructions for the Vango Enclosed Side Canopy. This document outlines the steps to properly set up your canopy, including pole assembly, Ring & Pin system usage, tensioning, and securing with guylines and pegs. I'm here to assist with any specific questions you might have about the procedure or limitations mentioned in the document. How can I help you today?
  • Where should the canopy be used?
    What should be avoided when pitching the canopy?
    How to begin assembling the canopy?
IF YOU HAVE ANY PROBLEMS PLEASE CONTACT YOUR LOCAL RETAILER or
AMG Group Ltd., Kelburn Business Park, Port Glasgow, Scotland. PA14 6TD.
UK Consumer Hotline: 0844 811 0535 E-Mail: [email protected].uk
Calls to our Customer Hotline cost 5p per minute. Calls from mobile phones, cable networks or public payphones will generally cost more.
Pitching Instructions – Enclosed Side Canopy
Pitching Instructions
Assemble the poles and insert into pole sleeves.
Locate one end of the poles in Ring & Pin system as Figure 1 below.
Push poles into an arch from opposite side and locate other pole end on to
corresponding Ring & Pin system on flysheet.
Tension the webbing strap at the pole end.
Position the open end of canopy towards tent.
Secure in position by pulling guylines attached to canopy roof over tent roof and
pegging on opposite side of tent.
Peg out canopy base at contact point with tent and then front of canopy to tension
material.
Secure in position by pegging out front guy lines.
Peg out ALL remaining peg points as figure 2.
The Vango Enclosed Side Canopy is designed for use in lowland sheltered campsites.
Do not pitch in high winds or exposed campsites.
Figure 1.
Figure 2.
/