WaterWay 810-0190 User manual

  • Hello! I've reviewed the provided user manual for the Proclean Manifold. This document contains the steps to correctly install the unit including how to use Teflon tape on threaded adapters, and how to properly seat the gasket rib. I'm ready to help you with any questions you might have about the installation process or the device itself.
  • How many wraps of Teflon tape are required on the adapter?
    Where should the gasket rib be placed?
    Where is the inlet label located after installation?
CHAMPION / PROCLEAN MANIFOLD INSTALLATION
1. Install threaded union adapters on inlet to filter and discharge
(top) of pump, using Teflon tape supplied. Use four wraps of the
Teflon tape on adapter for proper seal.
2. Make sure “rib on gasket is seated into the slot on the manifold
union assembly.
3. Finished installation should look like the picture in
Figure 3. The Inlet label is on top and before the union
going into the filter.
Teflon taped
tailpiece
threaded
into “inlet” and
discharge
Gasket rib should be seated
into slot
Inlet Label
WARRANTY
For product registration visit: www.waterwayplastics.com.
For Warranty questions or claims please contact point of purchase.
810-0190.0618
©2018 Waterway Plastics
2200 East Sturgis Road, Oxnard CA 93030 • Phone 805.981.0262 • Fax 805.981.9403
www.waterwayplastics.com • [email protected]
Designed,
Engineered &
Manufactured
in the USA.
/