Bauknecht DDLI 3710 IN Program Chart

Category
Cooker hoods
Type
Program Chart

This manual is also suitable for

Bauknecht DDLI 3710 IN-1 is a cooker hood designed to purify the air in your kitchen by removing grease and odors effectively. It features 5 different extraction speeds, allowing you to adjust the suction power based on your cooking needs. The intensive extraction speed setting provides a quick boost to eliminate intense odors and vapors. To maintain a clean and fresh kitchen environment, the hood comes equipped with grease filters that can be easily removed and cleaned once a month.

Bauknecht DDLI 3710 IN-1 is a cooker hood designed to purify the air in your kitchen by removing grease and odors effectively. It features 5 different extraction speeds, allowing you to adjust the suction power based on your cooking needs. The intensive extraction speed setting provides a quick boost to eliminate intense odors and vapors. To maintain a clean and fresh kitchen environment, the hood comes equipped with grease filters that can be easily removed and cleaned once a month.

DDLI 3710
5019 100 75073/B
INSTALLATIONSANGABEN
Mindestabstand zur Kochfläche: 65 cm (Elektroplatten), 75 cm (Gas-, Öl-,
Kohlekochplatten).
INSTALLATION SHEET
Minimum height above cooker: 65 cm (electric cookers), 75 cm (gas, gas oil
or coal cookers).
FICHE D’INSTALLATION
Distance minimale par rapport à la cuisinière : 65 cm (cuisinière électrique),
75 cm (cuisinière à gaz, mazout ou charbon).
INSTALLATIESCHEMA
Min. afstand van het kooktoestel: 65 cm (elektrische kooktoestellen), 75 cm
(kooktoestellen op gas, olie of kolen).
FICHA DE INSTALACIÓN
Distancia mínima desde los quemadores: 65 cm (quemadores eléctricos),
75 cm (quemadores a gas, gasóleo o carbón).
FICHA DE INSTALAÇÃO
Distância mínima do fogão: 65 cm (fogões eléctricos), 75 cm (fogões a gás,
óleo ou carbono).
SCHEDA INSTALLAZIONE
Distanza minima dai fuochi: 65 cm (fuochi elettrici), 75 cm (fuochi a gas,
gasolio o carbone).
ùüùü+ùñùþ
ü$12.)12.1.)2"0120" FP02!"0120" FP0120"
.0! #02!0. #0! #.
D
GB
F
NL
E
P
I
GR
Abluftstutzen Ø 120 mm nur für Hauben in der
Dunstabzugsversion - A
Ø 120 mm adapter for extractor - version A only
Réducteur Ø 120 mm uniquement pour la version aspirante - A
Adapter Ø 120 mm, uitsluitend voor aanzuigversie - A
Adaptador Ø 120 mm sólo para el Modelo aspirador - A
Redutor de Ø 120 mm apenas para a versão de aspiração - A
Riduttore Ø 120 mm solo per Versione aspirante - A
0&1ØPP) . 2 0..!!)31$
75073b.fm5 Page 1 Tuesday, February 29, 2000 12:15 PM
5019 100 75073/B
DDLI 3710
F
Vorderseite-Rückseite
Front-rear side
Côté avant-arrière
Voorkant-achterkant
Lado anterior-posterior
Lado frontal/posterior
Lato anteriore-posteriore
ü!)"1&0#!
Nicht mitgeliefert
Not provided
Non fourni
Niet bijgeleverd
No suministrado
Não fornecido
Non fornito
û0.!$02.
75073b.fm5 Page 2 Tuesday, February 29, 2000 12:15 PM
5019 100 75073/B
DDLI 3710
4
a
2
3
Fig. 1
5
1
1.
Control panel.
2.
Grease filters (supplied ready for installation).
3.
Grease filter handles.
4.
Lighting unit.
5.
Telescopic flue.
REPLACING BULBS -
Fig. 1
1.
Unplug the appliance or switch off the mains
power supply.
2.
Remove screw (
a
) and detach the lighting unit.
3.
Remove the burn-out bulb. Use only PL max
9W bulbs.
4.
Remount the lighting unit and secure with
screw (
a
).
CLEANING THE GREASE FILTER
Wash the grease filter once a month, or whenever
the grease filter saturation indicator flashes
(Extraction speed indicator
2
).
1.
Unplug the appliance or switch off the mains
power supply.
2.
Remove the grease filters.
- pull the grease filter handles downwards and
disengage from the rear slot (
b, c - Fig. 2
).
3.
After cleaning the grease filter remount in
reverse order, making sure the entire
extraction surface is covered.
Resetting the grease filter saturation
indicator:
press the extractor OFF button for
three seconds. The grease filter saturation
indicator will stop flashing.
FITTING OR RENEWING THE CARBON
FILTER
1.
Unplug the appliance or switch off the mains
power supply.
2.
Remove the grease filters.
3.
Fit the carbon filter, fixing it with the two
screws supplied (
d - Fig. 3
).
4.
If the filter needs renewing, remove the old
filter and fit a new one.
Renew the carbon filter once a year and also
whenever the carbon filter saturation indicator
flashes (Extractor speed indicator
3
).
5.
Remount the grease filters.
CONTROL PANEL
1.
Speed decrease control -
5
Ö
1
.
2.
Extraction OFF button.
3.
Extraction ON speed increase button -
0
Ö
5
.
4.
Extraction speed indicator
1
.
5.
Extraction speed indicator
2
and grease filter
saturation indicator (when flashing).
6.
Extraction speed indicator
3
.
7.
Extraction speed indicator
4
.
8.
Extraction speed indicator
5
.
9. Intensive
extraction speed indicator.
10.
Timer intensive speed button.
The hood operates at this speed for 5 minutes
and then returns to the previous settings.
This function can be cancelled by pressing
button
1
,
2
or
3
.
11.
Light ON-OFF switch.
3
1
2
3
45678 9
10 11
b
c
d
d
Fig. 3
Fig. 2
F NL E PD GR
PRODUCT DESCRIPTION SHEET
I
GB
75073b.fm5 Page 4 Tuesday, February 29, 2000 12:15 PM
1 / 1

Bauknecht DDLI 3710 IN Program Chart

Category
Cooker hoods
Type
Program Chart
This manual is also suitable for

Bauknecht DDLI 3710 IN-1 is a cooker hood designed to purify the air in your kitchen by removing grease and odors effectively. It features 5 different extraction speeds, allowing you to adjust the suction power based on your cooking needs. The intensive extraction speed setting provides a quick boost to eliminate intense odors and vapors. To maintain a clean and fresh kitchen environment, the hood comes equipped with grease filters that can be easily removed and cleaned once a month.

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Ask the document