Rugged Ridge Modular Over Rider Installation guide

Brand: Rugged Ridge

Model: Modular Over Rider

Type: Installation guide

11541.14

JK Wrangler Modular XHD Aluminum Hoop Over Rider

Contents:

1. Aluminum Hoop Over Rider (1)

2. M6 Hex Head Bolts (8)

3. M6 Flat Washer (16)

4. M6 Nylock Nut (8)

1. Remove aluminum front bumper if previously installed. Disconnect the fog lights by twisting the plug in

the rear of the light housings. Slide bumper off frame and set onto soft surface to avoid damage to

powder coating.

2. Place hoop over rider onto top of bumper. Hoop should be facing forward (pic.1). Align mounting

holes in hoop base with slotted holes located on top of bumper. Install M bolts, washers and nuts

(pic.2). Center hoop and tighten bolts.

Page 1 of 1

Rev. 8/11 PB

Note: When installing optional accessories, it is helpful to review XHD Aluminum bumper instructions

(11541.01). Installation of Hoop can be aided by removing bumper cover.

(pic. 1) (pic. 2)

3. Following bumper instruction sheet reinstall bumper and hoop onto vehicle and secure. Reconnect light

harness to fog lights.

For Technical Assistance Contact:

OMIX-ADA Tech Support

Phone: 1-800-449-6649

Email: [email protected]

Web: www.omix-ada.com

Copyright Omix-Ada 2011

1

Rugged Ridge Modular Over Rider Installation guide

Brand: Rugged Ridge

Model: Modular Over Rider

Type: Installation guide

Download PDF

Related papers

Other documents