2. Rugged Ridge
  3. Front Bumper Stubby End Caps

Rugged Ridge Front Bumper Stubby End Caps Installation guide

  • Hello! I've reviewed the installation instructions for the Rugged Ridge Modular XHD Aluminum Stubby Ends. This document provides a step-by-step guide for attaching the stubby ends to a bumper, along with a parts list and contact information. I'm ready to assist you with any questions you have about the product or the instructions.
  • What parts are included?
    What is the first step in installation?
    Is the bumper required for installation?
11541.10
JK Wrangler Modular XHD Aluminum Stubby Ends
Contents:
1. Aluminum Stubby End (2)
2. M12 Hex Head Bolts (6)
3. M12 Flat Washer (12)
4. M12 Hex Nut (6)
5. M12 Lock Washers (6)
Page 1 of 1
Rev. 8/11 SB
For Technical Assistance Contact:
OMIX-ADA Tech Support
Phone: 1-800-449-6649
Email: [email protected]
Web: www.omix-ada.com
Copyright Omix-Ada 2011
1. Insert (1) M12 hex bolt into the lower bolt hole on the side of the bumper using a washer on both the
inside and outside then fasten with hex nut and lock washer on the inside of the bumper. Do not
tighten at this time. Repeat for opposite side.
2. Insert a M12 hex bolt and washer thru the top holes in the stubby end. Install the stubby end onto the
bumper by sliding the notch cutout on the lower portion of the end onto the bottom bolt. Line up the
top bolts with the bumper and insert them into the bumper fastening with a hex nut and washer.
Tighten all bolts. Repeat for opposite side.
Note: Bumper must first be installed on vehicle.
/