®
InterMetro Industries Corporation
North Washington Street, Wilkes-Barre, PA 18705
For Product Information Call: 1-800-433-2232
Visit Our Web Site: www.metro.com
ASSEMBLY
INSTRUCTIONS
ASSEMBLY
INSTRUCTIONS
For the Equipment Platform
Equipment Platform
LIST OF
COMPONENTS
For the Assembly of the
Equipment Platform
CART WITH EQUIPMENT PLATFORM
Model No. LEC9600A
Item Description Qty.
A. Equipment Platform 1
B. Bolt
1
/
4
-20 Hex Head 2
C. Washer 2
D. Washer 4
E. Hex Nut
1
/
4
-20 4
A
E
D
C
B
®
InterMetro Industries Corporation
North Washington Street, Wilkes-Barre, PA 18705
For Product Information Call: 1-800-433-2232
Visit Our Web Site: www.metro.com
Equipment Platform
L01-110
Rev. A
8/95
Information and specifications are subject to change
without notice. Please confirm at time of order.
3. Slip a large washer over each stud
from the inside of the cart and install
the nuts provided until tight.
4. Slip a large flat washer over each
bolt and then from the inside, slip the
bolts through the holes provided in
the bottom of the tub (See Note 1).
5. Fit the support wires over the bolts
and slip a small flat washer onto the
bolts. Install a nut onto each bolt and
tighten (Fig. 2).
NOTE: The equipment platform is not
to be used as a foot rest.
Max. weight load capacity 30 lbs.
NOTE 1: The following drilling
operation may be required on
your cart.
If holes in the bottom of your cart are
not 10
3
/
4
” apart, drill 2-
5
/
16
diameter
holes per diagram A.
ASSEMBLY
INSTRUCTIONS
For Equipment Platform
1. With the entry mechanism in
the retracted position, remove
the backboard.
2. Take the equipment platform and
with the handles and ledge up, fit the
threaded studs into the holes on the
handle side of the cart (Fig. 1).
Fig. 1 Fig. 2
DIAG. A
THIS COMPLETES THE ASSEMBLY
OF THE EQUIPMENT PLATFORM.
-
1
-
2
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
Other documents
-
Metro L01-319 Operating instructions
-
-
-
-
-
-
-
-
-