Page is loading ...
ETC Setup Guide
DIN Rail Enclosures
Corporate Headquarters
Middleton, WI, USA
Tel +608 831 4116
Service: (Americas) [email protected]om
London, UK
Tel +44 (0)20 8896 1000
Service: (UK)
Rome, IT
Tel +39 (06) 32 111 683
Service: (UK) [email protected]m
Holzkirchen, DE
Tel +49 (80 24) 47 00-0
Service: (DE) techserv-hoki@etcconnect.com
Hong Kong
Tel +852 2799 1220
Service: (Asia) [email protected]
Web: etcconnect.com
© 2017 Electronic Theatre Controls, Inc.
Product information and specifications subject to change. ETC intends this document to be provided in its entirety.
7180M2270
Rev D
Released 2017-11
Overview
This document covers the installation of the Large DIN Rail Enclosure (ETC Part 7180A1018),
Small Vertical DIN Rail Enclosure (ETC Part 7180A1019), and Small Horizontal DIN Rail Enclosure
(ETC Part 7180A1019-H).
Installation
It is recommended that you remove any electronics before drilling holes in the enclosure. Remove any metal
shavings from the enclosure before installing electronics and connecting power.
1: Remove the four or eight screws securing the front cover of the DIN Rail Enclosure to access to the
mounting keyholes.
2: Use the measurements provided in the following diagrams for mounting bolt locations.
3: Secure the DIN Rail Enclosure to a fire resistant surface, such as drywall, masonry, or concrete, using
four bolts (mounting hardware not provided).
14”
(356 mm)
14”
(356 mm)
10.5”
(267 mm)
0.95”
(24 mm)
11”
(279 mm)
1.75”
(44 mm)
14”
(356 mm)
14”
(356 mm)
11”
(279 mm)
0.95”
(24 mm)
1.75”
(44 mm)
10.5”
(267 mm)
350.92 mm
266.70 mm
14”
(356 mm)
10.5”
(267 mm)
1.75”
(44 mm)
28”
(711 mm)
24.5”
(622 mm)
0.95”
(24 mm)
Small Vertical DIN Rail Enclosure,
back view
Large DIN Rail Enclosure,
back view
Small Horizontal DIN Rail Enclosure,
back view
ETC Setup Guide
DIN Rail Enclosures
DIN Rail Enclosure Installation Kits Page 2 of 2 ETC
4: Install the voltage barrier in one of five possible locations in the small DIN Rail Enclosure or one of
eleven possible locations in the large DIN Rail Enclosure using four screws as shown below.
5: Install the DIN rail products on the provided DIN rails.
6: Finish installation as specified in the installation manual provided with the DIN-mounted products.
7: Replace the cover and secure it with the four or eight screws removed earlier.
Large DIN Rail Enclosure
Small DIN Rail Enclosure
/
