2. BLOTZ
  3. B10-ME-004

BLOTZ B10-ME-004, B10_ME_004 Assembly Instructions

  • Hello! I have reviewed the instructions for the Building Middle East B10-ME-004 model. The document provides a step-by-step guide on how to assemble the model, including the use of glue, a modeling knife, and sandpaper. I am here to answer your questions about the assembly process and the product.
  • What kind of glue is needed?
    What tools are needed for assembly?
    Can I use pegs or elastic bands during assembly?
10mm Middle East #4
B10-ME-004
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and
remember to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in place
while you allow glue to dry.
Remove the front and rear walls of the building
plus the two roof pieces from the sprue.
Glue the roof sections to the walls as shown – note the
positions of the hatches on each level.
Take the side walls.
Glue these to the building as shown.
Glue the building to the base.
Add the two Stepped pieces
Add the outer wall.
The completed building.
/