Spectrum Industries 37331, Modesty Panel Owner's manual

  • Hello! I'm here to assist you with the assembly instructions for the Pivot Workstation 37331 modesty panel. This document outlines the steps to properly install the laminate insert and attach the panel to your workstation, ensuring a secure and correct setup. I've reviewed the instructions and can help answer any questions you have about it.
  • What should I do if parts are damaged during shipment?
    What tools are required for assembly?
    What is included in the package?
Tools
Required
or
0190789 Page 1 of 2
Assembly Instructions
Important
Before you begin, read and comply with all safety and operating instructions,
and ensure all parts and correct quantities are included.
Any parts damaged during shipment must be reported within 5 days of receipt.
To report information regarding missing parts or damage, to purchase parts
or accessories, or if you have any questions, please contact us.
www.spectrumfurniture.com
800-235-1262, 715-723-6750
Thank you for purchasing Spectrum products!
1. Install laminate insert
Modesty Panel (with insert)
for Pivot Workstation
37331
(1) 0138361
Laminate insert
1. Slide the laminate insert into the modesty panel. (Color side out)
Figure 1.
(1) 0138392
Right corner
(1) 0138391
Left corner
(1) 0138360
Modesty panel
(8) 0101382
#14 x 7/8” PHSM
(1) 037542
#8 x 5/8” PHSM
(1) 0134099
Bracket
Figure 1
Modesty panel
Laminate insert
0190789 Page 2 of 2
925 FIRST AVENUE, CHIPPEWA FALLS, WI 54729 / 800-235-1262 / 715-723-6750 / WWW.SPECTRUMFURNITURE.COM
© 2018 Spectrum Industries Inc., All rights reserved.
Figure 2.1 Figure 2.2
Modesty Panel
Mounting
bracket
2
1
Left Corner Right Corner
2. Install modesty panel
1. Carefully ip the workstation upside-down onto a non-abrasive surface.
This may require 2-3 people.
2. Orient the modesty panel and corners as shown and lock together.
Figure 2.1.
(4) #14 x 7/8” PHSM
Worksurface
1
2
4. Align the modesty panel, bracket, and worksurface mounting holes.
Figure 2.3.
5. Attach to worksurface with (8) #14 x 7/8” PHSM screws. Figure 2.4.
6. Secure mounting bracket with (1) #8 x 5/8” PHSM screw.
3. Place the mounting bracket inside the panel pocket. Figure 2.2.
Figure 2.3 Figure 2.4
Assembled
modesty panel
(1) #8 x 5/8” PHSM
/