Page is loading ...
Important
Before you begin, please make sure all parts and proper quantities
are included. Any parts damaged during shipment must be reported
within 15 days of receipt. To report information regarding damage, to
purchase parts or accessories, or if you have any questions, please
contact us at:
www.spectrumfurniture.com
715-723-6750, 800-235-1262
Thank you for purchasing Spectrum products!
Assembly Instructions
Figure 1
(1) 0114290
keyboard tray
keyboard slide
bracket
Keyboard tray installation
1. If possible, install the keyboard tray with the worksurface face down.
2. Pull the keyboard tray slides out and align the slide bracket mounting
holes with the pre-drilled worksurface mounting holes. Figure 1.
(3) 052608
3/4” x 5” Velcro® strap
#8 x 3/4” PHSM
(8 req’d)
keyboard tray
Note: If the worksurface does not have predrilled mounting holes, use the
slide brackets as a template to mark the mounting hole locations onto the
worksurface with a pencil, then drill each hole location with a 1/8” drill bit
about 3/4” deep. Be careful not to drill completely through the worksurface.
3. Install (8) #8 x 3/4” PHM screws through the slide brackets and tighten securely.
4. Use slots in tray & Velcro straps to secure cords.
Phillips
screwdriver
1/8” drill bit
(optional)
Tools Required
electric drill
(optional)
underside of
worksurface
(8) 026073
#8 x 3/4” PHSM screw
0114784R2 Page 1 of 1
Assembly Instructions
925 First Avenue, PO Box 400, Chippewa Falls, WI 54729 Ph: 800-235-1262, 715-723-6750 Fax: 800-335-0473, 715-738-2309
E-mail: [email protected] web: www.spectrumfurniture.com
Keyboard Tray
55356
/