1
Intermec EasyCoder 501 XP/601 XP
EasySet Bar Code Wand Setup
1. Connect the EasySet bar code wand to the
receptacle on the printer’s rear plate.
2. Read the appropriate bar code to set up the prin-
ter. Hold the wand like a pencil and move it
rather swiftly across the bar code.
3. When the bar code has been accepted, the prin-
ter emits a short beep and the Ready control
lamp on the printer’s front blinks briefly.
4. This sheet only contains a selection of setup
options. For information on how to produce your
own setup bar codes, please refer to the Inter-
mec Fingerprint 7.12 Reference Manual.
Serial Communication on ”uart1:”
Baudrate
1-960438-02 EasySet Bar Code Sheet for EasyCoder 501 XP/601 XP, Edition 3, September 1998
Connect here!
2
Serial Communication on ”uart1:”, cont’d.
No. of Stop Bits
RTS/CTS
ENQ/ACK
XON/XOFF, Data to Host
Reset comm. to default
Parity
Char. Length
3
Peel Off
Start- and Stopadjust
Cut Off
Tear Off
Media
Contrast
XON/XOFF, Data from Host
New Line
Serial Communication on ”uart1:”, cont’d.
4
Media, cont’d.
Media Width
Media Length
5
Media, cont’d.
Print Speed
Test Labels
Media Type
Media Length, cont’d.
6
Direct Thermal Printing (Europe)
Paper Type
Direct Thermal Printing (USA)
7
Thermal Transfer Printing (Europe)
Paper Type, cont’d.
8
Thermal Transfer Printing (USA)
Paper Type, cont’d.
-
1
-
2
-
3
-
4
-
5
-
6
-
7
-
8
Intermec EasyCoder 501XP Reference guide
- Type
- Reference guide
- This manual is also suitable for
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
-
Intermec EasyCoder 501XP Installation & Operation Manual
-
Intermec EasyCoder F4 Reference guide
-
-
-
-
-
Intermec EasyCoder E4 Installation & Operation Manual
-
-
-