Metra DP-6551 User manual

DP-6551
Metra
Brand
Metra
Model
DP-6551
Category
Car kits
Type
User manual

Metra DP-6551 is a dash kit designed specifically for installing a DDIN aftermarket radio into select Dodge Ram 1500 and 2500/3500 models. It provides a custom fit and textured finish to seamlessly integrate the new radio with the vehicle's interior. The kit includes a replacement dash panel, radio brackets, retainers, screws, and panel clips for a complete installation. The DP-6551 allows for easy mounting of the aftermarket radio and restores the factory appearance of the vehicle's dashboard.

Metra DP-6551 is a dash kit designed specifically for installing a DDIN aftermarket radio into select Dodge Ram 1500 and 2500/3500 models. It provides a custom fit and textured finish to seamlessly integrate the new radio with the vehicle's interior. The kit includes a replacement dash panel, radio brackets, retainers, screws, and panel clips for a complete installation. The DP-6551 allows for easy mounting of the aftermarket radio and restores the factory appearance of the vehicle's dashboard.

Metra. The World’s Best Kits.® MetraOnline.com © COPYRIGHT 2021 METRA ELECTRONICS CORPORATION REV. 9/30/21 INSTDP-6551
INSTALLATION INSTRUCTIONS
DP-6551
Attention! Let the vehicle sit with the key
out of the ignition for a few minutes before
removing the factory radio. When testing the
aftermarket equipment, ensure that all factory
equipment is connected before cycling the
key to ignition.
KIT COMPONENTS
• A) Replacement dash panel • B) Radio brackets • C) Retainers • D) #8 x 1/4 “ Phillips screws (4) • E) Panel clips (12)
KIT FEATURES
• ISO DDIN radio provision
• Custom textured dash panel with a DDIN radio opening.
Dodge Ram 1500 1998-2001/
Dodge Ram 2500/3500 1998-2002
Visit MetraOnline.com for more detailed information about the product and up-to-date vehicle
specific applications
Not designed for 1998 models with single knob headlamp switch or
12 volt power outlet in upper right corner of the dash
TOOLS REQUIRED
• Panel removal tool • Phillips screwdriver
• 3/8” Socket wrench • Cutting tool • Scribe tool
TABLE OF CONTENTS
Dash Disassembly ..................................................2
Kit Preparation .......................................................2
Kit Assembly ..........................................................3
WIRING & ANTENNA CONNECTIONS
(sold separately)
Wiring Harness: 70-1817
Antenna Adapter: Not required
A B C D E
386.257.1187
|
MetraOnline.com
2
1. Cut or grind the plastic welds from the
rubber trim around the steering column
area of the factory dash panel.
2. Secure the factory rubber trim to the
replacement dash panel with the
supplied retainers and screws.
3. Remove factory vents and snap them
into the replacement dash panel.
(Figure A)
4. Install the (12) panel clips to the
replacement dash panel.
5. Cut the sub-dash to allow room for the
radio assembly. (Figure B)
Continue to Kit Assembly
DASH DISASSEMBLY
1. Unclip, unplug and remove the
dashboard trim panel. (Figure A)
2. Remove (2) 3/8” hex-head screws
securing the radio to the dash. Slide the
radio out, then unplug and remove
Continue to Kit Preparation
(Figure A)
KIT PREPARATION
(Figure D)
(Figure B)
Remove shaded areas
REV. 9/30/2021 INSTDP-6551 3
KIT ASSEMBLY
(Figure A)
1. Secure the radio brackets to the radio
using the screws supplied with the
radio. (Figure A)
2. Locate the factory wiring harness and
antenna connector in the dash and
complete all necessary connections to
the radio. Metra recommends using
the proper mating adapter from Metra
and/or Axxess. Test the radio for proper
operation.
3. Secure the radio assembly to the dash
using the factory screws.
4. Reassemble the dash in reverse
order of disassembly to complete the
installation.
KNOWLEDGE IS POWER
Enhance your installation and fabrication skills by
enrolling in the most recognized and respected
mobile electronics school in our industry.
Log onto www.installerinstitute.edu or call
386-672-5771 for more information and take steps
toward a better tomorrow.
®
Metra recommends MECP
certified technicians
Metra. The World’s Best Kits.® MetraOnline.com © COPYRIGHT 2021 METRA ELECTRONICS CORPORATION REV. 6/17/21 INSTDP-6551
INSTALLATION INSTRUCTIONS
DP-6551
Having difficulties? We’re here to help.
Contact our Tech Support line at:
386-257-1187
Or via email at:
techsupport@metra-autosound.com
Tech Support Hours (Eastern Standard Time)
Monday - Friday: 9:00 AM - 7:00 PM
Saturday: 10:00 AM - 7:00 PM
Sunday: 10:00 AM - 4:00 PM
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4

Metra DP-6551 User manual

DP-6551
Metra
Brand
Metra
Model
DP-6551
Category
Car kits
Type
User manual

Metra DP-6551 is a dash kit designed specifically for installing a DDIN aftermarket radio into select Dodge Ram 1500 and 2500/3500 models. It provides a custom fit and textured finish to seamlessly integrate the new radio with the vehicle's interior. The kit includes a replacement dash panel, radio brackets, retainers, screws, and panel clips for a complete installation. The DP-6551 allows for easy mounting of the aftermarket radio and restores the factory appearance of the vehicle's dashboard.

Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents