2. Addonics Technologies
  3. ADIDESA

Addonics Technologies ADIDESA Installation guide

  • Hello! I am an AI chatbot trained to assist you with the Addonics Technologies ADIDESA Installation guide. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
ADDONICS TECHNOLOGIES
Model: ADIDESA
Installation Guide
Front View
Back View
Note: It is required to set up the IDE hard drive you are
connecting to the converter as a MASTER device.
1. Locate the 40-pin IDE connector of your IDE drive.
2. Connect the converter board to the IDE connector of the
hard drive.
3. Using the provided Y-power cable, connect the 4-pin
Molex connector to the power connector on the hard
drive. This will provide power to the hard drive.
4. At the other end of the Y-power cable is the 4-pin floppy
power connector which you connect to the converter.
Now connect the SATA cable to the SATA port on the
converter and the other end connect it to an onboard
SATA port or an add-in SATA card.
TECHNICAL SUPPORT
Addonics Technologies Phone: 408 433-3899
2466 Kruse Drive Fax: 408 433-3898
San Jose CA 95131
Email: http://www.addonics.com/sales/query/
Internet: http://www.addonics.com
Technical Support (8:30 am to 6:00 pm PST)
Phone: 408 433-3855
Email: http://www.addonics.com/support/query/
SATA Port
4-Pin Floppy
Power Connector
40-pin IDE Connector
IDE Connector
4-pin Molex
Power Connector
Master or Slave
Jumper Settings
/