Addonics Technologies ADIDEU2 User manual

Brand
Addonics Technologies
Model
ADIDEU2
Type
User manual
ADDONICS TECHNOLOGIES
Model: ADIDEU2
Installation Guide
Front View
Back View
Note: It is required to set up the IDE hard drive you are
connecting to the converter as a MASTER device.
1. Locate the 40-pin IDE connector of your IDE drive.
2. Connect the converter board to the IDE connector of the
hard drive.
3. Using the provided Y-power cable, connect the 4-pin
floppy connector to the power connector of the
converter. This will provide power to the converter.
4. At the other end of the Y-power cable is the 4-pin Molex
power connector that you connect to the hard drive.
5. Now connect the B-type USB cable to the USB port on
the converter or use the USB pin header cable.
TECHNICAL SUPPORT
Email: http://www.addonics.com/sales/query/
Internet: http://www.addonics.com
Technical Support (8:30 am to 6:00 pm PST)
Phone: 408 433-3855
Email: http://www.addonics.com/support/query/
USB Pin
Header
4-Pin Floppy
Power Connector
40-pin IDE Connector
IDE Connector
4-pin Molex
Power Connector
Master or Slave
Jumper Settings
B-Type USB cable USB Pin Header
cable
B-Type USB
Connector
  • Page 1 1

Addonics Technologies ADIDEU2 User manual

Brand
Addonics Technologies
Model
ADIDEU2
Type
User manual
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents