George Kovacs P592-084 User manual

P592-084
Brand
George Kovacs
Model
P592-084
Type
User manual

This manual is also suitable for

INSTALLATION INSTRUCTIONS
05/10/2012
READ AND SAVE THESE INSTRUCTIONS
WARNING! SHUT POWER OFF AT FUSE OR CIRCUI T BRE AKER.
AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.
Fig. 1
Fig. 2
HANGING THE FIXTURE (Fig. 1)
1. Carefully remove the fixture from the carton and check
that all parts are included as shown in the illustration.
2. Shut off power at the circuit breaker and remove old
fixture including the crossbar.
3. Attach the Crossbar (A) to the Outlet Box using the two
screws (C). The side of the Crossbar marked “GND”
must face out.
4. Thread Studs (B) 1/4” into the pre-drilled holes in the
Crossbar (A) spaced at the same distance apart as the
holes in the canopy (D).
5. Determine desired distance from ceiling to hang the
fixture, thread the necessary Bars (M) together onto
the Canopy (D) and Fixture body.
6. Place Glass Shade (J) into the Metal Ring (L), place
Holder (F) to the Metal Ring outside (L) secure with
Screws (K).
CONNECTING THE WIRES (Fig. 2)
7. At this point, connect the electrical wire as shown in
figure 2, making sure that all wire connectors are
secured. If your outlet has a ground wire (green or bare
copper), connect the fixtures Ground Wire to it.
Otherwise, connect the fixture Ground Wire directly to
the crossbar using the Green Screw provided.
FINISHING THE INTALLATION (Fig. 1)
8. After the wires are connected, carefully tuck them
inside the outlet box ,then place Canopy (D) over Studs
(B) and secure it tightly with Knurled Knobs (E).
9. Install the light bulb in accordance with the fixture’s
specifications. (DO NOT EXCEED THE MAXIMUM
WATTAGE RATING!) (NE PAS DEPASSER LA
PUISSANCE NOMINALE MAXIMALE!)
10. Place Glass Shields (G) over studs on the Support
Plate (I) then secure with Knurled Knobs (H).
Your installation is now complete. Return power to the
junction box and test the fixture.
Note: Illustration (Fig. 1) on this manual is for
installation purposes only. It may or may not be
identical to the fixture purchased
FIXTURE
WIRES
Black or
Smooth
HOUSE
WIRES
Black
(Hot)
FIXTURE
WIRES
White or
Ribbed
HOUSE
WIRES
White
(Neutral)
FIXTURE
WIRES
Bare
Copper
(Ground)
HOUSE
WIRES
Green
(Ground)
D
Junction Box
A
B
C
E
M
L
K
J
I
H
G
F
IMPORTANT: FIXTURE SHOULD BE INSTALLED BY
A QUALIFIED ELECTRICIAN TO ENSURE PROPER
WIRING AND INSTALLATION.
  • Page 1 1

George Kovacs P592-084 User manual

P592-084
Brand
George Kovacs
Model
P592-084
Type
User manual
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents