George Kovacs P034-077 User manual

Brand
George Kovacs
Model
P034-077
Type
User manual
INSTALLATION INSTRUCTIONS
05/10/2012
READ AND SAVE THESE INSTRUCTIONS
WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.
AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.
Fig. 2
Fig. 1
ASSEMBLING THE FIXTURE (Fig. 1)
1. Shut off power at the circuit breaker and remove old
fixture from ceiling, including the crossbar.
2. Carefully unpack your new fixture and lay out all the
parts on a clear area. Take care not to lose any small
parts necessary for installation.
3. Connect Bars (G) and Light Body (H) into a
combination.
4. Determine length desired and thread the combination
to Canopy (E) to the desired length.
5. Attach the Crossbar (B) to the Outlet box in the ceiling
with two screws (C). The side of the Crossbar with
“GND” marked on it and two convex points must face
out.
CONNECTING THE WIRES (Fig. 2)
6. At this point, Connect the electrical wires as shown in
Fig. 2, making sure that all wire connectors are
secured. If your outlet has a ground wire (green or
bare copper), connect the fixture’s Ground Wire to it.
Otherwise, connect the fixture’s Ground Wire directly
to the crossbar using the Green Screw provided.
FINISHING THE INSTALLATION (Fig.1)
7. Secure Canopy (E) by threading Studs (D) 1/4” into the
pre-drilled holes in the Crossbar (B) spaced at the
same distances apart as the holes in the Canopy (E).
8. Carefully lift the Canopy (E) through the Canopy’s
pre-drilled holes to both Threading Studs (D). Secure
Canopy against ceiling with Knurled Knobs (F).
9. Place Glass Shield (I) on the Support Plate of Light
Body (H), and secure it tightly using Knurled Knobs (J).
10. Secure Pipe (K) tightly on the end of fixture.
11. Install Light bulbs in accordance with the fixture’s
specifications. (DO NOT EXCEED THE MAXIMUM
WATTAGE RATING) (NE PAS DEPASSER LA
PUISSANCE NOMINALE MAXIMALE!).
12. Place Plastic Washer (L), Glass Shields (M) over
Pipe (K) and secure them tightly using Finial (N).
Your installation is now complete. Return power to the
outlet box and test fixture.
Note: Illustration (Fig. 1) on this manual is for
installation purposes only. It may or may not be
identical to the fixture purchased.
LA-1000E
FIXTURE
WIRES
Black or
Smooth
HOUSE
WIRES
Black
(Hot)
FIXTURE
WIRES
White or
Ribbed
HOUSE
WIRES
White
(Neutral)
FIXTURE
WIRES
Bare
Copper
(Ground)
HOUSE
WIRES
Green
(Ground)
IMPORTANT: FIXTURE SHOULD BE INSTALLED BY
A QUALIFIED ELECTRICIAN TO ENSURE PROPER
WIRING AND INSTALLATION.
J
I
A
D
B
C
F
G
E
H
K
L
M
N
  • Page 1 1

George Kovacs P034-077 User manual

Brand
George Kovacs
Model
P034-077
Type
User manual
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents