Hampton Bay P034-077 Installation guide

Brand
Hampton Bay
Model
P034-077
Type
Installation guide
INSTALLATION INSTRUCTIONS
03/24/2006
WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.
Fig. 1
Fig. 2
ASSEMBLING THE FIXTURE (Fig. 1)
1. Shut off power at the circuit breaker and remove old fixture from
ceiling, including the crossbar.
2. Carefully unpack your new fixture and lay out all the parts on a
clear area. Take care not to lose any small parts necessary fo
r
installation.
3. Connect Bars (G) and Light Body (H) into a combination.
4. Determine length desired and thread the combination to Canop
y
(E) to the desired length.
5. Attach the Crossbar (B) to the Outlet box in the ceiling with two
screws (C). The side of the Crossbar with “GND” marked on it
and two convex points must face out.
CONNECTING THE WIRES (Fig. 2)
6. At this point, Connect the electrical wires as shown in Fig. 2,
making sure that all wire connectors are secured. If your outlet
has a ground wire (green or bare copper), connect the fixture’s
Ground Wire to it. Otherwise, connect the fixture’s Ground Wire
directly to the crossbar using the Green Screw provided.
FINISHING THE INSTALLATION (Fig.1)
7. Secure Canopy (E) by threading Studs (D) 1/4” into the pre-drilled
holes in the Crossbar (B) spaced at the same distances apart as
the holes in the Canopy (E).
8. Carefully lift the Canopy (E) through the Canopy’s pre-drilled
holes to both Threading Studs (D). Secure Canopy against ceiling
with Knurled Knobs (F).
9. Place Glass Shield (I) on the Support Plate of Light Body (H), and
secure it tightly using Knurled Knobs (J).
10. Secure Pipe (K) tightly on the end of fixture.
11. Install Light bulbs in accordance with the fixture’s specifications.
(DO NOT EXCEED THE MAXIMUM WATTAGE RATING).
12. Place Plastic Washer (L), Glass Shields (M) over Pipe (K) and
secure them tightly using Finial (N).
Your installation is now complete. Return power to the outlet box and
test fixture.
Note: Illustration (Fig. 1) on this manual is for installation
purposes only. It may or may not be identical to the
fixture purchased.
LA-1000E
FIXTURE
WIRES
Black or
Smooth
H
O
USE
WIRES
Black
(Hot)
FIXTURE
WIRES
White or
Ribbed
H
O
USE
WIRES
White
(Neutral)
FIXTURE
WIRES
Bare
Copper
(Ground)
H
O
USE
WIRES
Green
(Ground)
J
I
A
D
B
C
F
G
E
H
K
L
M
N
  • Page 1 1

Hampton Bay P034-077 Installation guide

Brand
Hampton Bay
Model
P034-077
Type
Installation guide
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents