George Kovacs P854-084 User manual

Brand
George Kovacs
Model
P854-084
Type
User manual
INSTALLATION INSTRUCTIONS
For Model P854-084/647
READ AND SAVE THESE INSTRUCTIONS
WAR N I NG ! SH UT P O W E R O F F AT FU S E O R C I R C U I T B R E AK E R.
AV E R T I S S E ME N T ! CO U P E R L E CO U R AN T AU N I V E AU DE S F U S I B L E S O U D U D IS J O N C T E U R .
Fig.1
HANGING THE FIXTURE (Fig. 1)
1. Carefully remove the fixture from the carton and check
that all parts are included as shown in the illustration.
2. Shut off power at the circuit breaker and remove the old
fixture including the mounting hardware.
SUGGESTED INSTALLATION (Fig. 1)
3. Thread the two mounting studs (B) into the pre-drilled
holes in crossbar (A) (You can adjust the length of the
mounting studs if necessary）.
4. Attach the crossbar (A) to the outlet box with mounting
screws (C) (size: #8-32N*L0.5”). The side of crossbar
（A) marked ”GND” must face out.
CONNECTING THE WIRES (Fig. 2)
5. While holding the fixture body (E) toward the ceiling.
Connect the electrical wires as shown in figure 2, making
sure that all wire connectors are secured. If your outlet
box has a ground wire (green or bare copper), connect
the fixture’s ground wire to it and secure with wire
connectors, otherwise, connect the fixture’s ground wire
directly to the crossbar using the green screw provided.
After wires are connected, tuck them carefully into the
ceiling junction box.
COMPLETING THE INSTALLATION (Fig. 1)
6. Attach fixture body (E) to mounting studs (B) and secure
with knurled knobs (D).
7. Install the light bulb (not included) in accordance with
fixtures specifications. (DO NOT EXCEED THE
MAXIMUM WATTAGE RATING!)(NE PAS DEPASSER
LA PUISSANCE NOMINALE MAXIMALE!)
8. Place metal ring (H) into glass panel (I) and then place
glass shade (G) into metal ring (H).
9. Align glass assembly (G), (H) and (I) to studs (K). While
supporting the glass assembly, secure with finials (F).
Repeat step 9 for each finial (F).
Your installation is now complete. Return power to the
junction box and test the fixture.
Note: Illustration (Fig. 1) on this manual is for installation
purposes only. It may or may not be identical to the
fixture purchased.
LA-2244E
Set# A-010
-Crossbar
-Ground screw
-Mounting Screw*2
I
G
E
D
F
B
H
A
K
  • Page 1 1

George Kovacs P854-084 User manual

Brand
George Kovacs
Model
P854-084
Type
User manual
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents