Vestil FLP series Owner's manual

Brand: Vestil

Model: FLP series

Type: Owner's manual

VESTIL MANUFACTURING CORPORATION

2999 North Wayne St., Angola, IN 46703

Ph: 260-665-7586 • Fax: 260-665-1339

E-mail: [email protected] • www.vestil.com

INSTALLATION INSTRUCTIONS

1. A concrete pad will need to be poured for

installation. Use 3000 psi minimum strength

concrete. The size of the pad will need to be 30"

x 30" x 42" depth. The top surface must be level

in order for the flagpole to be plumb once

installed.

2. Allow concrete to set up for at least 24 hours.

3. Once concrete has fully set, center the base

plate on the concrete pad and mark out all holes

onto the concrete. Remove the base plate and

using a concrete hammer drill equipped with a 3/

4" diameter masonry drill bit, drill all holes out to

a depth of 7".

4. After all holes are drilled, place base plate back

on the concrete pad. With the base plate sitting

level on the pad, check for plumb of the pole.

Shimming maybe required at this point to bring

pole plumb.

5. Insert 3/4" sleeve anchor concrete bolts x 6"

length into each hole in the base plate, tapping

the bolts into place maybe required to set the

bolts in the full depth. Tighten the bolts in a

crosswise pattern to insure the plate stays level

on the pad.

Revised 10-02

STAINLESS STEEL FLAGPOLES

MODEL FPL

OWNER'S MANUAL

2

Scissor Lift Table

XII

II

I

XI

X

VI

VII

VIII

VI

V

III

IX

Time is money.

Increased productivity

equals greater profitability,

cost minimization and worker

compatibility. Ergonomic

products will assist you

with your production and

safety goals.

Mobile Lift & Tilt

Work Stand

Pallet Server

Material Handling Problem Solvers

Ground Lift Tilter

45° Container Tilter

High Rise Lift

Copyright 2002 T&S Equipment Company

1
2

Vestil FLP series Owner's manual

Brand: Vestil

Model: FLP series

Type: Owner's manual

Related papers

Other documents