Danfoss SpeedUp - Cement screed User guide

Application sheet

SpeedUp

Carpet / tiles / parquet / laminate / synthetics

Cement-screed

1 Carpet / tiles / parquet

2 Cement-screed (≥ CT-F4) 45 mm

3 System foil

4 SpeedUp heat panel + FH composite pipe 30 mm

5 Support batten (30mm)*

6 Basic perimeter insulation

7 Sound insulation 6/8 mm 6 mm

Floor nish NA mm Carpet / tiles / parquet / laminate / synthetics

Construction height 81 mm Height excluding oor nish

Weight ~ 93 kg / m² Weight excluding oor nish

Thermal resistance R 0,97 m²K / W The minimum thermal resistance requirement of EnEV is fullled.

Thermal transmission coecient U 0,87 W / m²K

Design load ≤ 2,0 kN / m²

Point load (≥ 20 cm²) ≤ 1,0 kN

Impact subsonic noise reduction 27 dB Test value according to DIN ISO 140-8; applies to concrete slabs

thicker than 12 cm (DIN 4109: m’ > 276 kg/m²)

Application area

Residential spaces, hallways and attic spaces in residential buildings and hotel rooms.

Corresponds to categories A1, A2 and A3 of DIN 1055-3.

Requirements & special features

The screed thicknesses must be adjusted in case of higher design load or point load

values.

* Construction without a stabilising support batten is also possible.

Observe all installation instructions and manufacturer’s instructions.

Additional insulation

This construction applies to residential partition slabs between rooms at the same tem-

perature. No additional insulation is necessary. See “Overview of maximum additional

insulation” with regard to allowable equalisation insulation.

Construction

according to EnEV, EN 1264, DIN 1055, 18202 and 4108

Construction number 44

Technical Data Floors/ceilings between rooms at the same temperature

VA.CR.I1.02

Danfoss HES