30mm
1.2"
ø 2 5 m
ø 3/32"
Step 1
Option A
Option B
35mm
1.4"
ø 6 m
ø 1/4"
3
Step 2
Wood Stud
Concrete/Brick Wall
Drill holes at the marked positions. Place the Bracket A over the marked screw
locations. Insert Screws B into the mounting holes and tighten using a screwdriver.
Drill holes at the marked positions. Insert the Anchors C into the mounting holes. Place
the Bracket A over the marked screw locations. Insert Screws B into the mounting holes
and tighten using a screwdriver.
Guide the Dot 2nd Gen to the bracket. Tie the power cord with Velcro Strap D if needed.
C
A
D
B
B
A