2. Edision
  3. Extension IR Receiver over Coax EDI-Rx

Edision Extension IR Receiver over Coax EDI-Rx User manual

  • Hello! I've reviewed the EDISION EDI-Rx User's Guide. This document outlines how to use the IR receiver over coaxial, including installation, features and troubleshooting. The guide explains how to connect the device, use it for remote control, and provides technical specifications. I'm ready to answer your questions regarding the EDI-Rx.
  • How do I connect the IR EDI-Rx to my existing RF network?
    How do I connect the IR EDI-Rx to my TV?
    How do I control another TV by IR?
    How do I power the IR EDI-Rx?
User’s Guide
EDI-Rx
IR over COAX
3
CONTENTS
►INTRODUCTION .............................................................................4
►INSTALLATION EXAMPLE ..............................................................4
►FEATURES ......................................................................................5
►TECHNICAL SPECIFICATIONS ......................................................5
►CONNECTIΟΝ & OPERATION .......................................................6
►PACKAGE INCLUDES ....................................................................6
►TROUBLESHOOTING .....................................................................7
4
► INTRODUCTION
The Extension IR Receiver over Coax EDI-Rx offers the
ability to control the connected audio/video source,
from another room TV point, through the existing coaxi-
al cable connection using your existing remote control.*
*Note that the HDMI Modulator Xtend is required to be installed as well
TV
ROOM
USB PORT
ANT IN
TV SOCKET,
RF SPLITTERS,
TAPS,EXISTING RF
NETWORK,etc...
SMATV
TV
COAXIAL CABLE
COAXIAL
CABLE
COAXIAL CABLE
USB to DC CABLE
IR CONTROL
SYSTEM EDI-Rx
JACK to IR Rx
CABLE
RF IN
RF OUTDC 5V
IR OUT
5
► FEATURES
• IR control over coaxial
• Ports - Connections: RF IN, RF OUT, IR OUT, DC 5V
• Power over DC to USB cable
• IR Signal LED
• Low Power Consumption
► TECHNICAL SPECIFICATIONS
Modulation Type ASK
Frequency bandwidth VHF III (174-230 MHZ)
& UHF (470-862 MHZ)
RF IN Input 1 x Female IEC-type
RF OUT Output 1 x Male IEC-type
IR Receiver OUT Stereo Jack 3,5mm (Jack to IR EDI-Rx)
DC OUT 5V/500mA (DC to USB cable)
IR Signal LED IR status indication
6
► CONNECTIΟΝ & OPERATION
1. Connect the RF OUT of the existing RF network to the RF
IN of the IR EDI-Rx (A).
2. From the RF OUT of the EDI-Rx (D), connect to the ANT
IN of the TV.
3. Connect the Jack to IR Rx cable from the IR Control Sys-
tem EDI-Rx (B) in front of the TV IR reception point, so as
to control it via IR.
4. Connect the DC5V input of the IR Control System EDI-Rx
(C) to a USB port of a TV/STB, using the cable USB-to-DC.
ΑB C D
Jack to IR Rx
cable
USB to DC
(5V) cable
► PACKAGE INCLUDES
1. IR Control System EDI-Rx
2. Jack to IR Rx cable
3. USB to DC (5V) cable
4. User Manual EN/DE/GR
7
► TROUBLESHOOTING
The IR control at the other TV point does not work
• Make sure that the Jack to IR Tx cable is close to the
audio/video source device.
• Make sure that there is a clear field between the IR
remote control and the Jack to IR Rx cable and the
distance between them is up to ~6 meters.
• In case the LED indication of the IR Control System
EDI-Rx is always ON, this may be caused by inter-
ference. Please relocate the device.
• Check the DC 5V power supply of the IR Control Sys-
tem EDI-Rx.
• Make sure that the IR signal coaxial cable path
does not include active devices such as amplifiers,
multiswitches etc.
For more queries or advanced troubleshooting,
please contact our technical support at [email protected]
The CE certificate of the product is available on our webpage,
by visiting this link: https://www.edision.gr/en/support
www.edision.gr
EDISION HELLAS LTD • FARMAKEIKA - 57001 N. RΙSIO • THESSALONIKI - GREECE
/