2. Futaba
  3. T8FG
T8FG

Futaba T8FG User manual

  • Hello! I have analyzed the provided user manual for Futaba's T8FG software update. This document outlines formatting of SD card, preparing update files onto the SD card, along with steps to initiate and complete the software update. I'm ready to help answer any specific questions you might have about procedure.
  • How to format the SD card?
    What files are required for the software update?
    How to start the software update?
1M23Z01302
-1-
T8FG software update manual
1. SD card format
You should format the SD card first by using T8FG. When the SD card is formatted, all the data is
deleted. Please do not format it when there is critical data.
1.1. Please attach the SD card in the SD card slot of T8FG.
1.2. Please turn on the power switch of T8FG. If the SD card not formatted is set, the following screen is
displayed. Please select "FORMAT" by scroll operation of touch sensor and touch “RTN”.
1.3. Please Select "OK" and touch “RTN”.
1.4. The following screen is displayed during formatting.
SD card slot
1M23Z01302
-2-
1.5. When the format is completed, the following screen is displayed.
1.6. Please turn off the power switch and detach the SD card from card slot.
2. Making of card for software update
2.1. Please unzip the zipped file. The following files will create.
・T8fgUpdate.exe ... File copy utility
・T8fgUpdate.dat ... Information file for T8fgUpdate.exe
・T8FG_UPDATE.dat … Identified file of T8FG
・T8FG_AP.bin ... Update file of T8FG (piece 3)
・T8FG_LD.bin ... Update file of T8FG (piece 2)
・T8FG_UPLD.bin ... Update file of T8FG (piece 1)
2.2. Please attach the SD card formatted to the card reader of PC.
2.3. Please run "T8fgUpdate.exe".
2.4. Please select the drive that attached the SD card. Click the "OK" button.
1M23Z01302
-3-
2.5. The following dialog is displayed. Click the "OK" button.
2.6. Update files is copied to SD card, the following screens are displayed. Click "END" button.
2.7. Please detach the SD card.
1M23Z01302
-4-
3. Update software of T8FG
1.1. Please change the slide switch to “UPDATE” side.
1.2. Please turn on the power switch. The following screen is displayed.
1.3. Please touch “RTN” for three seconds, a software update is begun.
1.4. When update is completed, the following screen is displayed. Please turn off the power switch.
1.5. Please detach SD card.
1.6. Please change the slide switch to right side.
1.7. Please check the software version at INFO in SYSTEM menu.
Slide switch
U
p
date Normal O
p
eration
/