5 0 1 6 1 6 3 5 1 9 2 4 7
Additional Features:
For installation near a TV or in a loft space
Ideal for weaker signal areas
High quality durable construction
Designed in the UK
1 year gaurantee
Specifications:
Frequency Range:
Power Supply:
Power Consumption:
Fully Screened:
Outputs:
Gain:
Switched Low Gain: 6dB (each output)
Noise:
Designed for continuous indoor use.
Application and user instructions inside
Safety Warnings:
> Always follow manufacturer’s operating and safety
instructions when using tools and/or equipment
> To avoid injury always route cables carefully
> Before making any connections switch electricity off
at the mains
> If in doubt consult a qualified electrician or
professional aerial installer
Connect the coaxial lead
from your TV or Radio and
aerial down leads (single or
diplexed) into the booster.
Key: A: Input B: Outputs
Installation Instructions:
1
2
Wideband for UHF TV and
VHF radio (40–790MHz)
Mains (230-240V)
Low (<5w)
Yes
4
10dB (each output)
>5dB
HGB4INS Iss 1
Contact:
Helpline:
Email:
Web:
+44 (0) 1553 811000
support@maxview.co.uk
www.maxview.co.uk
Iss 1
Gain Adjustment
The booster has a switched
gain. Push switch in for high
gain, out for low gain.
3
Permanent Fixing
Decide on the orientation
of the booster, taking into
consideration where the
cables run in and out.
Using the template (see
reverse) locate a suitable
position on a loft joist, inside
wall or skirting board. Mark
the screw hole positions.
For permanant wall of loft
fixing use No.8 or M4
countersunk head screws.
For wall fixing we also
recommend the use of wall
plugs.
4
5
To split the signal from the
output a TV/Radio Diplexer
and Flylead will be required
(not supplied). Plug into
a convenient UK mains
socket.
Application Example:
Fixing Template
TV and FM/DAB radio.
A diplexer can be used on input and outputs.
This Booster will supply up to 4 TV’s.
B
A
B
B
B
To other
outputs
FRONT PANEL - SHOWN IN PACKAGING