J58
© 2008 AS America Inc.
COLONY OVAL™
COUNTERTOP SINK
ENAMELED STEEL
COLONY OVAL™ COUNTERTOP SINK
• Acid-resisting enamel steel
• Front overow
• Self-rimming with cutout template supplied
• Two soap depressions
• Mounting clamps supplied
❏ 3004.207 Faucet holes on 4" (102mm) centers
Nominal Dimensions:
508 x 432mm
(20" x 17")
Bowl sizes:
381mm (15") wide
279mm (11") front to back
152mm (6") deep
Compliance Certications -
Meets or Exceeds the Following Specications:
• ASME A112.19.4M for Enameled Steel
Plumbing Fixtures
To Be Specied:
❏ Color: ❏ White ❏ Bone ❏ Silver ❏ Linen
❏ Faucet*:
❏ Faucet Finish:
❏ Supplies:
❏ 1-1/4" Trap:
* See faucet section for additional models available
NOTES:
*
DIMENSIONS SHOWN FOR LOCATION OF SUPPLIES AND “P" TRAP ARE
SUGGESTED.
FOR COUNTERTOP CUTOUT AND INSTALLATION INSTRUCTIONS USE
TEMPLATE SUPPLIED WITH SINK.
FITTINGS NOT INCLUDED WITH FIXTURE AND MUST BE ORDERED
SEPARATELY.
IMPORTANT: Dimensions of xtures are nominal and may vary within the
range of tolerances established by ANSI Standard A112.19.4.
These measurements are subject to change or cancellation. No responsibility
is assumed for use of superseded or voided pages.
432mm
(17)
508mm
(20)
181mm
(7-1/8)
(1-1/4) 32mm
DIA. HOLE
64mm
(2-1/2)
OPTIONAL
102mm
(4)
(4) RETAINERS FOR
MOUNTING LUGS
*330mm
(13)
184mm
(7-1/4)
6mm
(1/4)
203mm
(8)
178mm
(7)
*254mm
(10)
SUPPLIES AS REQ'D
1-1/4 O.D. WASTE
FINISHED
FLOOR
1-1/4 O.D. TAILPIECE
COUNTERTOP
(BY OTHERS)
FINISHED WALL
OR SPLASHBACK
787mm
(31) TO
FINISHED
FLOOR
(2) 29mm(1-1/8)
HOLES
SOAP DEPRESSIONS
CLAMPING DETAIL
LUG AND
SCREW
ASSEMBLY
COUNTERTOP
21mm
(13/16)
MAX.
Revised 2/08