Page is loading ...
K75
© 2006 American Standard Inc.
NOTES:
THIS COMBINATION IS DESIGNED TO ROUGH-IN AT A MINIMUM DIMENSION
OF 305MM (12") FROM FINISHED WALL TO C/L OF OUTLET.
*
DIMENSION SHOWN FOR LOCATION OF SUPPLY IS SUGGESTED.
SUPPLY NOT INCLUDED WITH FIXTURE AND MUST BE ORDERED
SEPARATELY.
FOR ADDITIONAL INFORMATION REFER TO INSTALLATION INSTRUCTIONS
SUPPLIED.
IMPORTANT: Dimensions of xtures are nominal and may vary within the range
of tolerance established by ANSI Standard A112.19.2
These measurements are subject to change or cancellation. No responsibility is
assumed for use of superseded or voided pages.
305mm
(12)
693mm
(27-5/16)
C/L OF OUTLET
84mm
(3-5/16)
FINISHED WALL
232mm
(9-1/8)
17mm ± 6mm
(11/16 ±1/4)
383mm
(15-1/16)
425mm
(16-3/4)
C/L
C/L OF SEAT POST HOLES
140mm (5-1/2 CENTERS)
308mm
(11-1/4)
159mm
(6-1/4)
16mm
(5/8)
FINISHED
FLOOR
752mm
(29-5/8)
232mm
(9-1/8)
152mm
(6)
505mm
(19-7/8)
*203mm
(8)
SUPPLY
AS
REQ'D
375mm
(14-3/4)
To Be Speci ed:
❏ Color: ❏ White ❏ Bone
❏ Seat: American Standard #5322.011 “Rise and
Shine" solid plastic closed front seat with cover.
❏ Seat: American Standard #5308.014 “Laurel"
molded closed front seat with cover.
❏ Alternate Seat:
❏ Supply with stop:
Revised 5/05
RENAISSANCE™
ROUND FRONT TOILET
VITREOUS CHINA
RENAISSANCE™ ROUND FRONT TOILET
❑ 2241.016
• Vitreous china
• Low-consumption (6.0 Lpf/1.6 gpf)
• 305mm (12") rough-in
• Round front bowl
• Close-coupled tank
• Color matched trip lever
• 2 bolt caps
• 100% factory ush tested
❑ 3338.011 Bowl
❑ 4037.017 Tank
Nominal Dimensions:
693 x 505 x 752mm
(27-5/16" x 19-7/8" x 29-5/8")
Fixture only, seat and supply by others
Compliance Certi cations -
Meets or Exceeds the Following Speci cations:
• ASME A112.19.2M for Vitreous China Fixtures -
includes Flush Performance, Ball Pass Diameter,
Trap Seal Depth and all Dimensions
/