SCANORAMA WELDING HELMET
Parts List
Scanorama Helmet 14F00
Filter plate density shade 9 14F04
Filter plate density shade 10 14F05
Filter plate density shade 11 14F06
Filter plate density shade 12 14F07
Filter disc (5 DIN) 14F08
Protective glass clear 14F09
Plugs (4) 14F11
Head band 14F12
Neck Protector 14F37
Sweat Band 14F43
OPERATING INSTRUCTIONS AND PARTS LIST
F15-082-E
SCANORAMA - The large tinted window (shade) gives you an unobstructed view of the
workpiece. During welding, look through the small dark filter plate (shades). The tinted win-
dow and filter plate gives a combined shade of 10. (OTHER SHADES CAN BE SELECTED BY
REPLACING THE FILTER PLATE).
NOTE:
Ideally suited for MIG & TIG applications up to 250 amps using Argon shielding.
Pitted or scratched plates reduce vision and protec-
tion. Replace worn or damaged parts immediately.
Avoid eye and face injury. Wear safety glasses and
use proper filter shade in helmet for arc or gas
welding applications. See ANSI/AWS Z49.1 for guide.
Available from: American Welding Society, Miami, FL
33135.
Be sure this information reaches the operator.
You can get extra copies through your supplier.
October, 2002
B. Cleaning
Do not use materials that are likely to damage plastics, e.g. gasoline, organic solvents, or abrasive cleaning
agents to clean the helmet and lens.
1. Remove excess dust from the helmets using a damp (water) cloth.
2. All the Protective Plates and Filter Plates should be cleaned in warm soapy water, rinsed in cold water. Wipe off
with a clean dry cloth. DO NOT use heat.
A. Adjusting Head Band
To Adjust Tilt Angle:
1. Loosen right side fastening nut.
2. Lift cam clear of locking screw and rotate to desired
adjusting slot.
3. Tighten fastening nut.
To Adjust Band Size
Smaller: Turn large adjusting knob at rear of band
clockwise.
Larger: Turn adjusting knob counter clockwise.
14F09 Clear
14F04 - Shade 9
14F05 - Shade 10
14F06 - Shade 11
14F07 - Shade 12
14F08 (Shade 5)
14F11
14F12
Scanorama Helmet
/