P/N 68-3498-01 Rev. A
Drill Template for the Extron
MMK 1
Page Size: 8.5" x 11"
Print Scale 1:1
Do not Shrink
e
1. Confirm the product to be installed
and make sure the page is not scaled.
2. Cut along the outer red line and tape the
template on the mullion where it will be installed.
Place the template so the solid black line
aligns with the front of the mullion.
3. Mark the center points of the drilling circles
and remove the template.
4. Drill 1/8" (3.2 mm) top and bottom pilot holes.
5. Drill a 5/8" (15.9 mm) max diameter
center hole to allow wires to exit the mullion.
6. Remove the template and follow the steps
in the Installation Guide.
Touchpanel Front
D= 1/8" (3.2mm)
D= 1/8" (3.2mm)
D= 5/8" max.
(15.9 mm) max.
LED starts
here
/
