Extron MMK 3 Template

P/N 68-3500-01 Rev. A

Drill Template for the Extron

MMK 3

Page Size: 8.5" x 11"

Print Scale 1:1

Do not Shrink

Touchpanel Front

Align with front

of mullion

D= 1/8" (3.2mm)

D= 5/8" max.

(15.9 mm) max.

1. Confirm the product to be installed

and make sure the template page

is not scaled.

2. Cut along the outer red line and

tape the template on the mullion

where it will be installed.

Place the template so the solid black

line aligns with the front of the mullion.

3. Mark the center points of the

drilling circles and remove the

template.

4. Drill 1/8" (3.2 mm) top and bottom

pilot holes.

5. Drill 5/8" (15.9 mm) max diameter

center hole to allow wires

to exit the mullion.

6. Remove the template and follow

the steps in the Installation Guide.