P/N 68-3499-01 Rev. A
Drill Template for the Extron
MMK 2
Page Size: 8.5" x 11"
Print Scale 1:1
Do not Shrink
e
1. Confirm the product to be installed
and make sure the template page
is not scaled.
2. Cut along the outer red line and
tape the template on the mullion
where it will be installed.
Place the template so the solid black
line aligns with the front of the
mullion.
3. Mark the center points of the
drilling circles and remove the
template.
4. Drill 1/8" (3.2 mm) top and bottom
pilot holes.
5. Drill 5/8" (15.9 mm) max diameter
center hole to allow wires
to exit the mullion.
6. Remove the template and follow
the steps in the Installation Guide.
Align with front
of mullion
Touchpanel Front
D= 1/8" (3.2mm)
D= 5/8" max.
(15.9 mm) max.
D= 1/8" (3.2mm)
/
