Highwood Stonecroft Board & Batten Shutter Assembly Instructions

  • Hello! I've reviewed the Assembly Guide for the Stonecroft Shutter. This document details the installation process, including how to mount the shutter, drill the necessary holes, and secure it using bolts. I'm ready to answer your questions about the installation or painting process outlined in the guide.
  • What size drill bit should I use for pilot holes in the wall?
    How many holes should I drill for shutters smaller than 55 inches?
    How many holes should I drill for shutters 55 inches and larger?
    What type of paint can be used on the shutters?
For information on Care and Cleaning or to register your
highwood product, please visit www.highwood-usa.com. PAGE 1 OF 2
INCLUDED TOOLS
532" HEX BIT
IMPORTANT!
DO NOT fully tighten the bolts until all
bolts are started. Once all bolts are inserted,
go back & tighten all the bolts.
Retain these instructions for future reference
HARDWARE
highwood
NATURE'S CLOSEST RIVAL
CUSTOMER-SUPPLIED TOOLS
Cordless screwdriver/drill
Home and Garden Collection
Stonecroft Shutter
Assembly Guide
1) Place the Shutter Next to the Window and Mark the
Desired Location of the Shutter. If Installing the Shutter on
Brick, the Mounting Screws Should be Positioned to Be in
Line with the Mortar Joints.
AD-SHUT1
02.21.20
A
2) When Installing Shutters Smaller than 55", Drill (4) 516"
Holes into the Shutter ONLY, in the Locations Shown in
Figure 1 to the Right.
When Installing Shutters 55" and Larger, Drill (6) 516" Holes
into the Shutter ONLY, in the Locations Shown in Figure 2 to
the Right.
3) Place the Shutter Next to the Window and Secure it
Using Either (4) or (6) of the "A" Bolts Provided. If a Pilot
Hole is Desired, Use a 316" Drill Bit to Pre-drill into the Wall.
For Masonry Installations, Use a Masonry Anchor Sized for a
14" Fastener. Pre-drill into the Wall Using the Appropriate
Size Drill Bit and Insert an Anchor into Each Hole. Secure
the Shutter using the Same "A" Bolts from Above.
x12
14" x 212" LAG SCREW
Top of Shutter
Window
Figure 1
(4) Screw Install
Figure 2
(6) Screw Install
See Reverse Side for Details on
Painting Your Stonecroft Shutters
For information on Care and Cleaning or to register your
highwood product, please visit www.highwood-usa.com. PAGE 2 OF 2
highwood
NATURE'S CLOSEST RIVAL
AD-SHUT1
02.21.20
Painting Your Stonecroft Shutters
Your Highwood shutters are ready for paint. Choose any color to match your trim, coordinate with your windows and
doors, or accent the facade of your home. Any high-quality exterior grade paint can be used. Acrylic enamels and alkyd
(oil-based) paints will provide the best performance. No sanding or priming is necessary. Ensure the shutters are free of
dust and any other foreign material, then simply brush, roll, or spray [airless sprayer] with your preferred quality exterior
paint. Do not use canned spray paint that contains any aromatic hydrocarbon (e.g., xylene, toluene).
Suggested brands include:
Rust Oleum Oil-Based Enamels
HGTV Home by Sherwin Williams Weathershield Exterior Paint
Valspar Duramax Exterior Paint
Behr Ultra Exterior Paint
/