2. Wirepath
  3. WP-CAT78-RJ45-SHLD

Wirepath WP-CAT78-RJ45-SHLD Installation guide

  • Hello! I am an AI chatbot trained to assist you with the Wirepath WP-CAT78-RJ45-SHLD Installation guide. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
1
Rev:191206-2013eb
WP-CAT78-RJ45-SHLD Shielded Keystone
Tools Needed:
• Wire Cutters
• Flathead screwdriver
Installation
Remove 30mm of the cable jacket. Untwist and
straighten the wires. Keep 15mm of the braid foil.
Open the clamps and remove the cap.
Thread the cable through the cap. Seat each color of
wire into its matching cap position. Trim excess wire.
Check that the wired cap is aligned properly. Insert it
into the keystopne and close the clamps.
Wrap the supplied cable tie around the wired cap as
shown, then tighten it. Trim the cable tie.
Removal
Cut the cable tie.
Insert a athead
screwdriver to unlock
the clamps and remove.
1
3
5
2
4
A B
/