2. Wirepath
  3. WP-CAT6-6A-RJ45-SHLD

Wirepath WP-CAT6-6A-RJ45-SHLD Quick start guide

  • Hello! I am an AI chatbot trained to assist you with the Wirepath WP-CAT6-6A-RJ45-SHLD Quick start guide. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
1
Rev:191014_1240
WP-CAT6-6A-RJ45-SHLD Shielded Keystone Quick Start Guide
Tools Needed:
• Wire Cutters
• Flathead screwdriver
Installation
1. Remove about 3cm of the cable sheath. Keep
about 15mm of the cable braid (foil).
2. Release the Cap.
3. Weave the cable end through the cap. Seat each
color coded wire into the matching cap position
and trim excess wire.
4. Check that the wired cap is in the correct
orientation and cover it with both jaws.
5. Thread the supplied cable tie through the wired
cap, then tighten around the braided shield. Trim
the cable tie.
Removal
1. Cut the cable tie.
2. Insert a athead
screwdriver to
unlock the wired cap
and remove.
/