Golden Lighting 2115-BA1 RBZ-OP Installation guide

Golden Lighting
Brand
Golden Lighting
Model
2115-BA1 RBZ-OP
Type
Installation guide

This manual is also suitable for

Golden Lighting 2115-BA1 RBZ-OP is a wall-mounted light fixture designed for indoor use. It comes with a mounting strap, mounting screws, deco nuts, a glass shade, a spacer, a socket ring, and a socket. The fixture can be used with a variety of light bulbs, but it is important not to exceed the maximum recommended wattage.

The fixture is easy to install and can be mounted on a junction box. The wires from the fixture should be connected to the power supply wires from the junction box, and the fixture should be secured to the wall with the mounting screws. The glass shade can then be slid over the socket and secured in place with the spacer and socket ring. Finally, a light bulb can be installed in the socket.

Golden Lighting 2115-BA1 RBZ-OP is a wall-mounted light fixture designed for indoor use. It comes with a mounting strap, mounting screws, deco nuts, a glass shade, a spacer, a socket ring, and a socket. The fixture can be used with a variety of light bulbs, but it is important not to exceed the maximum recommended wattage.

The fixture is easy to install and can be mounted on a junction box. The wires from the fixture should be connected to the power supply wires from the junction box, and the fixture should be secured to the wall with the mounting screws. The glass shade can then be slid over the socket and secured in place with the spacer and socket ring. Finally, a light bulb can be installed in the socket.

IMPORTANT:
• ALLINSTALLATIONWORKSHOULDBEDONEBYACCREDITEDPROFESSIONAL.
• SHUTOFFPOWERSUPPLYATFUSEORCIRCUITBREAKER!
• USEONLYTHESPECIFIEDBULBS.DONOTEXCEEDTHEMAXIMUMWATTAGE!
PREPARING FOR INSTALLATION
Removeallofthecontentsfromthecarton.Seetheimportantnotesabove.Shutoffthepoweratthecircuitbreakerandcompletely
removetheoldxturefromthewall,includingtheoldmountingstrap.
Mountingstrap(B)containsseveralpairsofthreadedholes.Findthepairofholesthatmatchesthespacingoftheholesonthejunction
boxandyourxture’sbackplate.Twoofmountingscrews(A)shouldbeattachedtomountingstrap(B).Youmayneedtotightenthenuts
thatholdthesescrewsinplace.Pullthehousewiresthroughthecenterofmountingstrap(B).Placemountingstrap(B)overthejunction
boxsothatmountingscrews(A)arehorizontal,andinalignmentwiththeholelocationsonxturebackplate(F).Securemountingstrap(B)
tothejunctionboxwithmountingscrews(D)andascrewdriver.Tightenthescrewssecurely.
CONNECTING THE WIRES
Attachthexture’swirestothepowersupplywiresfromthejunctionbox.Connectblacktoblack(orsmooth);whitetowhite(orribbed);
groundtoground(greenorcopper).Twisttheendsofthewirepairstogether,thentwistonawireconnector.Makesurealltwistsare
inthesamedirection.Ifthereisnogroundwire(greenorcopper)fromthejunctionbox,locategroundscrew(E)onmountingstrap(B)
andwrapthexture’sgroundwirearoundthegreengroundscrew(E).Useascrewdrivertosecuregroundscrew(E)ontothemounting
bracket.Tuckallwiresneatlyintothejunctionbox.
FINISHING THE INSTALLATION
Placethexture’sbackplate(F)overmountingscrews(A)sothattheyprotrudethroughtheholesinthefrontofthebackplate.Thread
deconuts(G)ontomountingscrews(A).Twistuntilthebackplateofthextureissnugagainstthewall.
Slideglass(I)overthesocketandsecureinplacewithspacer(J)andsocketring(K).
Installlightbulb(L-notincluded)inaccordancewiththexture’sspecications.Donotexceedthemaximumrecommendedwattage.
Yourinstallationisnowcomplete.Turnonthepowerandtestthexture.
BLACK
(Hot)
WHITE
(Neutral)
GREEN
(Ground)
HOUSE WIRES
SMOOTH
(Or Black)
FIXTURE WIRES
RIBBED
(Or White)
BARE COPPER
(Or Green)
For Customer Service, contact
the place of purchase to arrange
for replacement parts.
AssemblyInstructions:2115-BA1 (Constance)
CLEANING TIPS
Treat the xture gently! Regular cleaning will reduce the need for deep cleaning. For regular cleaning, turn off the light and wipe down the
xture with a clean lint-free cotton or microber cloth. Never spray cleaner directly onto the xture.
Completed Fixture
H
I
J
K
G
D
C
E
F
B
A
L
  • Page 1 1

Golden Lighting 2115-BA1 RBZ-OP Installation guide

Golden Lighting
Brand
Golden Lighting
Model
2115-BA1 RBZ-OP
Type
Installation guide
This manual is also suitable for

Golden Lighting 2115-BA1 RBZ-OP is a wall-mounted light fixture designed for indoor use. It comes with a mounting strap, mounting screws, deco nuts, a glass shade, a spacer, a socket ring, and a socket. The fixture can be used with a variety of light bulbs, but it is important not to exceed the maximum recommended wattage.

The fixture is easy to install and can be mounted on a junction box. The wires from the fixture should be connected to the power supply wires from the junction box, and the fixture should be secured to the wall with the mounting screws. The glass shade can then be slid over the socket and secured in place with the spacer and socket ring. Finally, a light bulb can be installed in the socket.

Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents