Golden Lighting THD1051OPBA2 Installation guide

Type
Installation guide
IMPORTANT:
• ALLINSTALLATIONWORKSHOULDBEDONEBYACCREDITEDPROFESSIONAL.
• SHUTOFFPOWERSUPPLYATFUSEORCIRCUITBREAKER!
• USEONLYTHESPECIFIEDBULBS.DONOTEXCEEDTHEMAXIMUMWATTAGE!
PREPARING FOR INSTALLATION
Removeallofthecontentsfromthecarton.Seetheimportantnotesabove.Shutoffthepoweratthecircuitbreakerandcompletely
removetheoldxturefromthewall,includingtheoldmountingstrap.
Mountingstrap(B)containsseveralpairsofthreadedholes.Findthepairofholesthatmatchesthespacingoftheholesonthejunction
boxandyourxture’sbackplate.Twoofmountingscrews(A)shouldbeattachedtomountingstrap(B).Youmayneedtotightenthenuts
thatholdthesescrewsinplace.Pullthehousewiresthroughthecenterofmountingstrap(B).Placemountingstrap(B)overthejunction
boxsothatmountingscrews(A)arehorizontal,andinalignmentwiththeholelocationsonxturebackplate(F).Securemountingstrap(B)
tothejunctionboxwithmountingscrews(D)andascrewdriver.Tightenthescrewssecurely.
CONNECTING THE WIRES
Attachthexture’swirestothepowersupplywiresfromthejunctionbox.Connectblacktoblack(orsmooth);whitetowhite(orribbed);
groundtoground(greenorcopper).Twisttheendsofthewirepairstogether,thentwistonawireconnector.Makesurealltwistsare
inthesamedirection.Ifthereisnogroundwire(greenorcopper)fromthejunctionbox,locategroundscrew(E)onmountingstrap(B)
andwrapthexture’sgroundwirearoundthegreengroundscrew(E).Useascrewdrivertosecuregroundscrew(E)ontothemounting
bracket.Tuckallwiresneatlyintothejunctionbox.
FINISHING THE INSTALLATION
Placethexture’sbackplate(F)overmountingscrews(A)sothattheyprotrudethroughtheholesinthefrontofthebackplate.Thread
deconuts(G)ontomountingscrews(A).Twistuntilthebackplateofthextureissnugagainstthewall.
Slideglass(I)overthesockets(H)andsecureinplacewithsocketrings(J).
Installlightbulbs(notincluded)inaccordancewiththexture’sspecications.Donotexceedthemaximumrecommendedwattage.
Yourinstallationisnowcomplete.Turnonthepowerandtestthexture.
BLACK
(Hot)
WHITE
(Neutral)
GREEN
(Ground)
HOUSE WIRES
SMOOTH
(Or Black)
FIXTURE WIRES
RIBBED
(Or White)
BARE COPPER
(Or Green)
For Customer Service, contact
the place of purchase to arrange
for replacement parts.
AssemblyInstructions:1051-BA2 (Hidalgo)
CLEANING TIPS
Treat the xture gently! Regular cleaning will reduce the need for deep cleaning. For regular cleaning, turn off the light and wipe down the
xture with a clean lint-free cotton or microber cloth. Never spray cleaner directly onto the xture.
J
I
H
B
G
A
C
D
F
E
  • Page 1 1

Golden Lighting THD1051OPBA2 Installation guide

Type
Installation guide

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI