NICOR T5C-22-MV-35 Installation guide

Type
Installation guide

This manual is also suitable for

NICOR, Inc. 2200 Midtown Place NE, Albuquerque, NM 87107 P: 800.821.6283 F: 800.892.8393 www.nicorlighting.com July 7, 2017 3:03 PM rev 1.0
T5C LED TROFFER
INSTALLATION INSTRUCTIONS
Carefully unpack the xture from its packaging. Inspect product
for defects due to shipping.
Locate desired positioning for xture in ceiling grid. Remove ceiling
tiles if necessary.
1
2
4
Place xture into the T-grid
ceiling panel. Secure to
structure and/or grid per
state and local codes.
Turn o power to appropriate circuit at
the breaker panel.
3
The installation must only be performed by a licensed electrician.
To prevent death, injury or damage to property, this product must be installed in accordance to National Electrical Code (NFPA70) in the US
or Canadian Electrical Code (CSA 22.1) in Canada.
Disconnect power before installing the product or servicing it.
Wait until xture has cooled down before installing or servicing the xture.
MIN. 90°C SUPPLY CONDUCTORS
What’s In The Box
One (1) T5C
LED Troer Wire Nuts
Tools Needed
This LED Troer requires very few tools for installation.
A drill or a screwdriver and a pair of wirecutter.
NICOR, Inc. 2200 Midtown Place NE, Albuquerque, NM 87107 P: 800.821.6283 F: 800.892.8393 www.nicorlighting.com July 7, 2017 3:03 PM rev 1.0
6
7
8
Connect wiring as shown. Grey and purple wiring are for 0-10V
dimming systems. Cap o if not used.
Turn power on and verify that the panel is lit.
Reattach cover of junction box and secure with (2) two screws.
Remove access plate from junction-box (do not discard) by
removing screws.
Other end is for low voltage connection.
5
Luminaire
LED Driver
White
Black
Com
Line
GND
Junction Box
RedRed
BlackBlack
*
*Cap o if not used
*
Grey
Purple
1-10V (-)
1-10V (+)
  • Page 1 1
  • Page 2 2

NICOR T5C-22-MV-35 Installation guide

Type
Installation guide
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI