Page is loading ...
NICOR, Inc. 2200 Midtown Place NE, Albuquerque, NM 87107 P: 800.821.6283 F: 800.892.8393 www.nicorlighting.com September 22, 2017 2:46 PM rev 1.0
TPE LED TROFFER
INSTALLATION INSTRUCTIONS
The installation must only be performed by a licensed electrician.
To prevent death, injury or damage to property, this product must be installed in accordance to National Electrical Code (NFPA70) in the US
or Canadian Electrical Code (CSA 22.1) in Canada.
Disconnect power before installing the product or servicing it.
Wait until xture has cooled down before installing or servicing the xture.
MIN. 90°C SUPPLY CONDUCTORS
What’s In The Box Tools Needed
One (1) TPE Edgelit LED Troer
Wire Nuts
This Edgelit LED Troer requires very few tools for installation. A
drill or a screwdriver and a pair of wirecutter. Sheet metal screws
can be used to attach the xture to the T-grid or framing.
Carefully unpack the xture from its packaging. Inspect product
for defects due to shipping.
Locate desired positioning for xture in ceiling grid. Remove ceiling
tiles if necessary.
1
2
4
Bend grid mounting tabs.
Turn o power to appropriate
circuit at the breaker panel.
3
NICOR, Inc. 2200 Midtown Place NE, Albuquerque, NM 87107 P: 800.821.6283 F: 800.892.8393 www.nicorlighting.com September 22, 2017 2:46 PM rev 1.0
6
7
8
Connect wiring as shown.
Turn power on and verify that the panel is lit.
Reattach cover of junction box and secure with screw.
Remove access plate from junction-box (do not discard) by
removing screws.
5
LED Driver
INPUT
Black
Red
OUTPUT
Gray
Purple
GND
Black
White
Junction Box
DIM +
DIM -
LED +
LED -
GND
4
Place xture into the T-grid
ceiling panel. Secure to
structure and/or grid per
state and local codes.
/
