NICOR T3R-22-S-MV-40 Installation guide

T3 RETROFIT ASSEMBLY

INSTALLATION INSTRUCTIONS

The installation must only be performed by a licensed electrician.

To prevent death, injury or damage to property, this product must be installed in accordance to

National Electrical Code (NFPA70) in the US or Canadian Electrical Code (CSA 22.1) in Canada.

Disconnect power before installing the product or servicing it.

Wait until xture has cooled down before installing or servicing the xture.

MIN. 90°C SUPPLY CONDUCTORS

Carefully unpack the xture from its packaging. Inspect product for

defects due to shipping.

Turn o power to appropriate circuit at the breaker box.

Remove old cover/tombstones/ballast/belly pan.

Place new mounting brackets on each side

Hang new xture from T-slots in mounting brackets

Connect wiring as shown. Grey and purple wires are for 0 - 10V dimming

systems. Cap o if not used.

Reattach cover of junction box and secure with two screws.

Lift xture into place and lock tabs into mounting bracket.

Turn power on and verify that the panel is lit.

NICOR, Inc. | 2200 Midtown Place NE, Albuquerque, NM 87107 | 800.821.6283 | www.nicorlighting.com | May 28, 2015 10:56 AM

Model(s):

Luminaire

LED Driver

White

Black

Com

Line

GND

Junction Box

Blue

RedRed

Grey

Purple

1-10V (-)

1-10V (+)

Blue*

*may be black wire with blue tag

T3R-22-S-MV-40