IF YOU HAVE ANY PROBLEMS OR QUESTIONS CONCERNING THIS PRODUCT,
DO NOT RETURN IT TO YOUR RETAILER, CONTACT CUSTOMER SERVICE AT
1-888-424-3354
041105rev2
Read the instructions and precautions before use of this product
Please keep this instruction manual for future reference
IF YOU HAVE ANY PROBLEMS OR QUESTIONS CONCERNING THIS PRODUCT,
DO NOT RETURN IT TO YOUR RETAILER, CONTACT CONSUMER SUPPORT AT
1-888-424-3354
OR
IF YOU ARE A STORE MANAGER OR EMPLOYEE IN NEED OF ASSISTANCE CALL
1-888-851-5569
PLEASE HAVE YOUR STORE NUMBER READY
Limited Warranty
World Factory, Inc.
®
Products for Home Use
World Factory, Inc.
®
(Seller) warrants to the original Buyer only, that each Astonica
®
Product will be
free from defects in material and workmanship for a period of one (1) year from date of purchase.
SELLER’S SOLE OBLIGATION AND BUYER’S EXCLUSIVE REMEDY UNDER THIS LIMITED
WARRANTY SHALL BE THE REPAIR OR REPLACEMENT OF PARTS, WITHOUT CHARGE, WHICH
ARE DEFECTIVE IN MATERIAL OR WORKMANSHIP. ANY PARTS AS DETERMINED BY THE
SELLER WHICH HAVE BEEN MISUSED; ABUSED OR DAMAGED EITHER DIRECTLY OR INDIRECTLY
FROM REPAIRS OR ALTERATIONS ATTEMPTED BY UNAUTHORIZED PERSONS; IMPROPER
MAINTENANCE, NEGLECT OR ACCIDENT ARE NOT COVERED BY THIS LIMITED WARRANTY. This
warranty does not apply to damage, heat-induced coloration changes, scratching or alteration due to
normal use or weathering. To make a claim under this Limited Warranty, you must return the complete
product with proof of purchase, transportation prepaid, to any World Factory, Inc.
®
authorized service
center. Call 1-888-424-3354 for the location of the nearest authorized service center.
Additional Limitations
THIS LIMITED WARRANTY DOES NOT APPLY TO ACCESSORY OR CONSUMABLE ITEMS RELATED
TO THIS PRODUCT. ALL IMPLIED WARRANTIES SHALL BE LIMITED IN DURATION TO ONE (1)
YEAR FROM DATE OF PURCHASE. IN NO EVENT SHALL SELLER BE LIABLE FOR ANY
INCIDENTAL OR CONSEQUENTIAL DAMAGES, INCLUDING BUT NOT LIMITED TO LIABILITY FOR
LOSS OF PROFITS, ARISING FROM THE SALE OR USE OF THIS PRODUCT.
If any provision of this Limited Warranty is for any reason held to be invalid or unenforceable, such
provision shall not affect any other provision herein, this Limited Warranty shall be construed as if
such invalid and/or unenforceable provision had never been contained herein.
This Warranty contains the entire agreement between Seller and Buyer and supersedes any and all
prior agreements, arrangements, or understandings between the parties relating to product warranty.
®
Made in China
©2005 World Factory, Inc.
Distributed by:
World Factory, Inc.
Coppell, TX 75019
Part Number: FenwickGRP06 / Model No: 50105155
Fenwick 3 pc Steel Seating Group
Instruction Manual
Due to ongoing product development
the actual product or products may vary from
the illustrations or photos shown within this manual.
NOTE: This product is intended for residential, non-commercial use.
PARTS LIST
CUSHION SWIVEL ROCKER
Manufactures Model No. 50105149 (Swivel Rocker Only)
PART # DESCRIPTION QUANTITY
IF YOU HAVE ANY PROBLEMS OR QUESTIONS CONCERNING THIS PRODUCT,
DO NOT RETURN IT TO YOUR RETAILER. CONTACT CUSTOMER SERVICE AT
1-888-424-3354
Carefully remove the contents from the package. If any parts are missing do not
attempt to use the product until they have been obtained and correctly installed.
ASSEMBLY INSTRUCTIONS
A Chair Frame 2
B Chair Base 2
C Chair Cushion 2
Figure 1
NOTE: This product is intended for residential, non-commercial use.
Figure 2
Parts Detail
A
B
1
1.(SEE FIGURE 1 and 2) Place chair base (B) on flat level surface.
2.Install chair frame (A) onto chair base (B). Push downward on chair frame.
3 Verify chair frame is fully seated into chair base. Attach chair cushion (C) to chair using straps.
NOTE: Do not use chair without chair cushions.
Using without cushions can cause damage to frame.
4 Your Swivel Rocker Chair is now ready for use.
C
A
B
C
A, B
ASSEMBLY INSTRUCTIONS
1.(SEE FIGURE 1) Place the table top (A) upside
down on a flat non-scratch surface.
2.Turn lower table legs (B) upside down, and
slide plastic retainers underneath table top
as necessary to align with legs.
PARTS LIST
20" GLASS TOP OCCASIONAL TABLE
Part Number: SurfsidENDTO6
Manufactures Model No. 50105143 (Occasional Table Only)
PART # DESCRIPTION QUANTITY
A
B
C
Figure 1
Figure 2
B
C
B
A
IF YOU HAVE ANY PROBLEMS OR QUESTIONS CONCERNING THIS PRODUCT,
DO NOT RETURN IT TO YOUR RETAILER. CONTACT CUSTOMER SERVICE AT
1-888-424-3354.
Carefully remove the contents from the package. If any parts are missing do not
attempt to use the product until they have been obtained and correctly installed.
A 1Tempered Glass Table Top
B 1Table Leg, Lower
C
1
Table Leg, Upper
1 (SEE FIGURE 3) Turn table upright.
Figure 3
1.(SEE FIGURE 2) Insert lower table legs (B)
into the plastic retainers, push down on
both ends of table legs until lower legs
snap into position.
2. Turn upper table legs (C) upside down,
align center slot with center slot of lower
tables legs (B) and push down to join.
3.Slide plastic retainers underneath table
top as necessary to align with
upper legs (C).
4.Insert upper legs (C) into the plastic retainers
and push down on both ends of table legs
until legs snap into position.
B
A
Parts Detail
NOTE: This product is intended for residential, non-commercial use.
2
3
-
1
-
2
-
3
