2. OSP Designs
  3. KAU320-BL

OSP Designs KAU320-BL, KAU320-LIN, KAU320-RD, TAH320-BK, TAH320-BL, TAH320-GRY, TAH320-RD, TAH320-WHT Operating instructions

  • Hello! I have reviewed the assembly instructions for the OSP Designs Tahiti and Kauai Swivel Rocker Chairs. This document details the necessary parts, hardware, and steps required to assemble your chair. I'm ready to answer any questions you may have about the assembly process.
  • What parts are included?
    What hardware is needed for assembly?
    How do I attach the cushion?
1. PARTS LIST
ASSEMBLY INSTRUCTIONS
UPPER CHAIR - 1 PC
ITEM CODE : IMS - 200320
TAHITI SWIVEL ROCKER CHAIR
REF CODE : TAH320-BK/TAH320-BL/TAH320-WHT/TAH320-GRY
KAUAI SWIVEL ROCKER CHAIR
REF CODE : KAU320-BL/KAU320-RD/KAU320-LIN
2. HARDWARE LIST
aa. M6 BOLTS
- 4 PCS
cc. FLAT WASHER
- 4 PCS
bb. SPRING WASHER
- 4 PCS
dd. SCREW DRIVER
- NOT PROVIDED
FRONT
BACK
a. SWIVEL ROCKER BASE- 1 PC b.
3. ASSEMBLY STEPS
3A. Align the FRONT &
BACK positions of Swivel
Rocker Hardware (b) &
bottom of Upper Chair (a).
X
FRONT
BACK
A
B
D
C
FRONT
BACK
A
B
D
C
D
C
B
A
A
A
A
A
bb
aa
cc
FRONT
POSITION
(THICKER SIZE)
BACK
POSITION
FRONT
BACK
D
C
B
A
FINISH
CUSHION - 1 PCc.
3B. Through the 4” hole underneath
the Swivel Rocker Base (b), align the first
hole (A) of Swivel Rocker Hardware to
the hole (A) of bottom Upper Chair (a),
and use (dd) Screw Driver (not provided)
to tighten hardware (aa) M6 Bolt, (bb)
Spring Washer, (cc) Flat Washer.
3C. Rotate the Swivel Rocker Base
(b), to align the next matching holes
(B, C & D) of Swivel Rocker Hardware
and bottom Upper Chair (a) and tighten
all the (aa) M6 Bolts, (bb) Spring
Washers and (cc) Flat Washers.
3D. After Assembly, stand the Rattan Swivel
Rocker Chair right up, and put the Cushion (c)
on, and then tighten all the Velcros on the
back of the Cushion to the Rattan Swivel
Frame.
dd
/