IF YOU HAVE ANY PROBLEMS OR QUESTIONS CONCERNING THIS PRODUCT,
CONTACT OVERSTOCK.COM CUSTOMER SERVICE AT
1-800-843-2446
180106rev1
Read the instructions and precautions before use of this product
Please keep this instruction manual for future reference
IF YOU HAVE ANY PROBLEMS OR QUESTIONS CONCERNING THIS PRODUCT,
CONTACT CONSUMER SUPPORT AT
1-800-843-2446
Warranty Information:
Products for Home Use
This item and or product is not covered under original manufacturer's warranty.
For warranty issues please contact the retailer directly at
1-800-843-2446
or
www.Overstock.com
Made in China
Distributed by:
Overstock.com
6350 South 3000 East
Salt Lake City, UT 84121
OV SKU No. 10085157-000-000
Model No. 50103304
Fallbrook Table
Instruction Manual
Due to ongoing product development
the actual product or products may vary from
the illustrations or photos shown within this manual.
NOTE: This product is intended for residential, non-commercial use.
IF YOU HAVE ANY PROBLEMS OR QUESTIONS CONCERNING THIS PRODUCT,
DO NOT RETURN IT TO YOUR RETAILER. CONTACT CUSTOMER SERVICE AT
1-800-843-2446.
Carefully remove the contents from the package. If any parts are missing do not
attempt to use the product until they have been obtained and correctly installed.
CAUTION: Do not to over tighten bolts. Aluminum is a soft metal and threads
can easily be stripped.
1.Turn the table top (A) upside down on a flat, non-scratching surface.
2.Screw the four threaded studs (D) into the threaded holes underneath the table top.
Do not over tighten.
3.Turn the leg (B) upside down, and connect it to the table top with one washer (E),
and one hex nut (F).
4.Repeat Step 3 with the remaining three legs (B).
5.Align one of the support rings (C) with the legs at the bottom tabs. Secure using four
flat head screws (G), flat washers (H), and hex nuts (I) to hold it in place.
NOTE: The ring should be mounted so that when the table is turned upright,
the ring is on top of the tabs.
6.Repeat Step 5 with the other support ring.
7.Stand the table upright. Tighten all bolts securely.
A
B
C
D
F
ASSEMBLY INSTRUCTIONS
Figure 1
E
G
H
I
Table top
Legs
Support Rings
8mm Threaded Studs
6mm Flat Head Screws
8mm Flat Washers
8mm Hex Nuts
6mm Flat Washers
6mm Hex Nuts
1
4
2
8
8
8
8
8
8
A
B
C
D
E F
G
H
I
D
E
F
A
B
G
H
I
C
DESCRIPTION
PART #
QUANTITY
PARTS & HARDWARE LIST
1
2
NOTE: This product is intended for residential, non-commercial use.
Parts Detail
/