1. (SEE FIGURE 1) Place table top (A) upside down on a non-scratching surface.
NOTE: One of the two leg assemblies center support should be
positioned lower to allow the second to fit on top.
2. Locate leg assembly with lower center support. Place leg assembly (B) upside down and
align mounting holes over threaded studs on table top. Install wing nuts (C)
and finger tighten. Repeat for second leg assembly (B) and hand tighten wing nuts (C).
CAUTION: Do not over tighten fasteners.
3. All four legs should sit flat. If the table rocks, you have the leg assembly mounted in reverse
order. If so, repeat steps 1 - 3 reversing the placement order of the legs.
ASSEMBLY INSTRUCTIONS
Carefully remove the contents from the package. If any parts are missing do not
attempt to use the product until they have been obtained and correctly installed.
PARTS & HARDWARE LIST
PART # DESCRIPTION QUANTITY
A
1Table Top
B
2
Leg Assembly
C
4
Wing Nut
A
B
C
Figure 1
C
C
B
A
C
C
B
IF YOU HAVE ANY PROBLEMS OR QUESTIONS CONCERNING THIS PRODUCT,
DO NOT RETURN IT TO YOUR RETAILER, CONTACT CUSTOMER SERVICE AT
1-800-843-2446.
Center Support
NOTE: This product is intended for residential, non-commercial use.
Parts Detail
1
2