RC4WD Fender Flares Owner's manual

Hello! I've reviewed the user manual for the RC4WD Fender Flares designed for the 1985 Toyota 4Runner. The document provides a step-by-step guide on how to install these flares, including details on identifying each part, drilling appropriate holes, and properly securing the flares. I'm ready to answer any questions you might have about the installation or the product itself.
What size drill bit should be used for the holes?

Is a nut needed for all screws?

Is it important not to over-tighten the screws?

Step 1.

Step 2.

Identifying each part

Use the fenders as a gulde to drill 1.5mm/2mm holes

RC4WD USA 100-0083

Front left Front right

Rear left Rear right

1

Use 1.5mm drill for these

holes and. thread the

screw into the body. a nut

is not used here

RC4WD Fender Flares for 1985 Toyota 4Runner

Φ1.5mm

Φ2mm

Front left Front right

Rear left Rear right

2mm

All 2mm holes

1.5mm1.5mm 1.5mm

Step 3. Use the fenders as a gulde to drill 1.5mm/2mm holes

RC4WD USA 100-0083

Step 4. Install the fenders, do not over tighten the screws

2

3-Steel Socket Head Cap

Screws M2 X 6mm

11-Steel Socket Head Cap

Screws M2 X 8mm

11-Regular M2 Black Nuts

RC4WD Fender Flares for 1985 Toyota 4Runner

/

Related papers

Other documents