RC4WD N-Fab N-Durastep User manual

  • I have reviewed the user manual for the RC4WD N-Fab N-Durastep intended for the 1/18 Gelande II model. This document provides a three-step installation process explaining how to attach the Durastep to your car using a 1.5mm hex driver and needle nose pliers. I am ready to answer any questions you may have about the installation or other aspects of the product.
  • What tools are needed for installation?
    How many bolts need to be removed in Step 1?
    Are nuts needed when reattaching the upper links and sliders?
Step 1. Step 2.
Step 3.
Using a 1.5mm hex driver and some needle nose
pliers, remove the 4 bolts that secure the upper
links to the chassis.
Reverse the direction of the screw and reattach
the upper links and sliders simultaneously. The
nuts are not needed.
Completed Assembly.
RC4WD 100-0047
RC4WD N-Fab N-Durastep
for 1/18 Gelande II
1/1